Dextra HBE3 M3 LE3 Folheto de instalação

Procurar online ou descarregar pdf Folheto de instalação para Equipamento de iluminação Dextra HBE3 M3 LE3. Dextra HBE3 M3 LE3 4 páginas.

HBE3 M3 LE3/LS3 Installation Leaflet

Voltage: 220-240V / 50-60Hz

LED Power: 1.8W

Battery: Li-FeP04 18650 3.2V 1500mAh

Operating Temperature: 0°C - 40°C

IP20

BEFORE installation, the electrical supply and battery pack MUST be disconnected.

Ceiling/Wall surface mount

Drill a hole in the ceiling and feed the cable through.

Drill two fixing holes and secure the cover in place

with two screws.

Connect the battery.

DIL-0300-0068

WARNING - THIS LUMINAIRE MUST BE EARTHED

This luminaire has been tested and is manufactured to comply with BS EN

60598 : specification for general requirements and tests. It should be installed by

a suitably qualified person in accordance with IEE.

CAUTION: there is a potential risk of electric shock from the LED boards when

the product is operational with the cover removed.

NOTE: INSTALLATION AND OPERATION OF THE LUMINAIRE BEYOND ITS

SCOPE OF SUPPLY WILL INVALIDATE THE WARRANTY.

Remove the top cover and drill the cable entry hole in

Pass the cable through and wire directly into the

terminal block. Secure the mains cable using the

Attach the fitting to the top cover and secure in place.

When wall mounting, rotate the body 90 degrees and

Revision - B

the indicated location.

internal cable clamp.

secure in place.

25/04/2022