Fencee 8227 Manual do utilizador - Página 11

Procurar online ou descarregar pdf Manual do utilizador para Vedações & Portões Fencee 8227. Fencee 8227 16 páginas. Automatic smart chicken door

When both are set, the door opener will use the Light Sensor as its primary

reference for closing. If it is not dark enough to close using the Light Sensor,

the default time you set will be used instead.

3. After the Closing mode setting, the screen displays SAVE, indicating the

end of the setting up process. After that, teh screen power down in 120

seconds later to save battery.

5. ANTI-PINCH FUNCTION

This function is designed to prevent your chickens from getting caught when

the door automatically closes (This function does not take effect when the

door is manually closed).

When the door is automatically closed and it finds that there is something

below blocking the door, it will automatically open to the highest point and

then close the door to try to remove the obstacle. This attempt is repeated

up to three times. If the door is not closed after three attempts, the screen

will display E2 and the light flashes slowly.

Battery-only or solar panel battery operation exhibits a different response to

the pinch function than adapter-only or battery adapter operation.

Battery operation even with a solar panel: responds reliably just above the

middle of the door opening and above, the distance from the bottom of the

opening increases with battery discharge.

Operation on adapter or adapter with batteries: responds reliably from the

middle of the door opening and above, here the response does not change

with battery discharge unless there is a power failure.

If the door gets stuck outside this reaction distance, it indicates a normal

closed state but is not physically open. Perform the basic cycle manually,

press the button to open the door

and then the button to close the door

when the door is closed. if this condition repeats, the closing parameters

must be reset in chapter 4.3.

lf the "E2" appears, and the light flashes quickly, it means that something

is preventing the door from closing during the automatic closing process.

Please remove the obstacle and then press the

button. Perform the basic

manual cycle, press the door open button

, when it reaches, then the door

close button

. The door will then begin to operate as previously set.

Low batteries affect anti-pinch function operation.