A.J.Antunes 9100480 Manual do Proprietário - Página 8
Procurar online ou descarregar pdf Manual do Proprietário para Utensílios de cozinha A.J.Antunes 9100480. A.J.Antunes 9100480 20 páginas. Miracle steamer
Imprimir página
MIRACLE STEAMER
READY
SINGLE SHOT
UP
DOWN
PRGM
START/STOP
POWER
Figure 3. Operating Controls
Operating Instructions
1. Turn the power on and allow the unit to preheat
for approximately 20-30 minutes.
NOTE: Do NOT push any button during warmup
time. The flashing green Ready Light indicates that
the unit is NOT warmed up. The green Ready Light
will become steady when the unit is warmed up.
2. Pull out the Drawer and set the product to be
steamed onto the Drawer.
3. Push the Drawer fully into the steamer.
4. Single Shot: Press and release the OPERATE
button, wait 20 seconds for the steam to pen-
etrate the product.
Timed Cycle: Press the START/STOP button to
begin the steaming cycle. The display will count
down to zero and an audio signal will sound at
the end of the steaming cycle.
5. Remove steamed product.
WARNING
To avoid injury, be careful when pulling Drawer
out from unit. Be sure to allow steam to escape
before putting hands or face over the steamer.
A.J. Antunes & Co.
OPERATION
Programming
Ready Light
CYC (Total Cycle Time) refers to the total pro-
grammed steam time set for the product.
Message
SHO (Shot Interval Time) is the time set between
Display
shots of steam during a complete cycle.
Start/Stop
H2O (Steam Shot Time) refers to the water volume
Button
used by the water pump or solenoid valve.
Operate
The amount of steam produced by the unit depends on
Button
the amount of water sprayed onto the steam generator.
Power
Switch
The generator may flood if the H2O setting is too high.
To prevent flooding, increase the Shot Interval Time
(SHO) to allow more time for generator heat recovery.
Adjustments should be made to both values to deter-
mine the best settings for your cooking needs.
To program the control, refer to Figure 4 and follow the
procedure below:
1. Turn the unit on. The unit displays the factory
programmed Total Cycle Time in minutes and
seconds (Figure 4, Item A).
2. Press and release
OPERATION to PROGRAM mode.
3. To change the Total Cycle Time in minutes, press
▲ or ▼ to change the time (Figure 4, Item B).
4. Press and release
▼ to change the Total Cycle Time in seconds
(Figure 4, Item C).
5. To change the SHO factory settings, go to
PROGRAM mode, then press and hold both
▲ and ▼ simultaneously for 1-2 seconds and
release. "SHO" will be displayed (Figure 4,
Item D).
8
to change the control from
again, and press ▲ or
P/N 1010456 Rev. C 08/12