Aqua Flo Flo-Master CP Series Manual do Proprietário - Página 2
Procurar online ou descarregar pdf Manual do Proprietário para Bomba de água Aqua Flo Flo-Master CP Series. Aqua Flo Flo-Master CP Series 9 páginas.
Imprimir página
INSTALLATION & OPERATING INSTRUCTIONS
WARNING − RISK OF ELECTRIC SHOCK
-
PROTECTED BY A GROUND
FAULT CIRCUIT
A QUALIFIED SERVICE REPRESENTATIVE
INSTALLATION MUST BE DONE BY A QUALIFIED ELECTRICIAN IN ACCORDANCE WITH
APPLICABLE ELECTRICAL CODES
,
MOTOR
BE CERTAIN THAT THE SOURCE OF ELECTRICAL POWER IS OFF AT THE MAIN JUNCTION
.
BOX
BONDING WIRE −
UPON INSTALLATION OF THE PUMP
(
)
WITH
NO SMALLER THAN
N
E
C
ATIONAL
LECTRIC
ODE
CONNECTOR ON THE MOTOR TO ALL METAL PARTS OF THE SWIMMING POOL
TUB STRUCTURE AND TO ALL ELECTRICAL EQUIPMENT
5
(1.5
PIPING WITHIN
FEET
M
,
TUB
WHEN THE MOTOR IS INSTALLED WITHIN
,
,
SWIMMING POOL
SPA
OR HOT TUB
N
: F
OTE
OR ELECTRICAL CONNECTIONS
GENERAL
Your AQUA-FLO pump has been quality built and engineered to give maximum
efficiency under normal water pumping conditions. Consult the manufacturer for
any other applications.
LOCATION OF PUMP
For best pump performance, locate the system as close to the water source as
possible. Provide adequate access around the pump for inspection and
maintenance.
MODELS LESS TRAP
This pump was designed for below water level (flooded suction) applications.
Make sure the pump is installed at a level that will allow the pump casing (volute)
to be completely filled with water.
Two quick disconnect compression fittings are included with your pump for ease
of installation and maintenance. Make sure the fittings are correctly aligned with
pump connections to allow the o-ring to make the proper seal. Hand tighten
only. Do not use a wrench to tighten fittings.
MODELS WITH TRAP
Avoid excessive tightening of pipe or fittings in any areas where threaded
connections are used.
For NPT threaded connections, use Quick-Seal Teflon Thread Sealing
Compound, Plasto-Joint Stick or any other sealants formulated specifically for
plastics.
-
. T
INTERRUPTER
.
A
LL ELECTRICAL WIRING OF THE MOTOR
. G
ROUNDING IS REQUIRED
2
N
.8 AWG (8.4
)
A
O
MM
. T
HE CONNECTION SHOULD BE FROM THE ACCESSIBLE WIRE
)
OF THE INSIDE WALLS OF THE SWIMMING POOL
5
FEET OF THE INSIDE WALLS OF THE
.
,
SEE WIRING DIAGRAM ON MOTOR RATING PLATE
2
. C
ONNECT ONLY TO A CIRCUIT
HE UNIT SHOULD BE INSTALLED BY
. B
EFORE WORKING ON ANY
,
THE MOTOR MUST BE BONDED
SOLID COPPER CONDUCTOR PER
,
,
SPA
OR HOT
,
METAL CONDUIT AND METAL
,
,
SPA
OR HOT
.