AQUA FORTE DRUMFILTER XL Manual de instruções - Página 4

Procurar online ou descarregar pdf Manual de instruções para Sistemas de filtragem de água AQUA FORTE DRUMFILTER XL. AQUA FORTE DRUMFILTER XL 10 páginas.

GENERAL INFORMATION

Read this manual carefully before installing the drum lter!
Keep this manual close to the drum lter so you can consult it at all times.
For external components (such as cleaning pumps) the manufacturer supplies separate manuals for installation and maintenance. Read
these manuals also carefully and follow the concerning instructions.
This manual does not include site/country speci c regulations, the installer of the drum lter is responsible for acting according these local
regulations.
The manufacturer of this drum lter is not responsible for damages or injuries as a result of not following this manual.
Factory warranty will be voided in case of incorrect use and/or not allowed modi cations by the installer/user.
Refrain from any unsafe actions! Always respect the basic safety regulations!
Regularly check the drum lter for correct and safe operation.
The manufacturer only grants warranty when the drum lter is used properly with original manufacturer parts.
SAFETY
Always be sure that the main power supply cable is removed from the wall outlet before doing any installation or maintenance!
WARNING: not following the safety instructions can lead to serious personal injuries or damages!
Always comply to the national and international safety regulations, apart from the safety instructions in this manual!

GENERAL FUNCTION

The drum lter will lter solid waste particles from the water. The water will enter the lter at this inlet chamber and then ow into the
drum. Waste particles will deposit on the inside of the drum which will decrease the output ow of clean water through the drum. This will
cause a change in water level inside and outside the drum. The level switch will detect this change in water level and send a signal to the
controller to activate the cleaning process. The controller will then activate the motor to rotate the drum and activate the power supply to
the cleaning pump/solenoid valve to provide the spray nozzles with water. The water pressure will rinse o the waste particles from the
drum. The dirty water will leave the lter through the waste gutter. You can choose to rinse with clean pond water (from outside the drum)
with an external (optional) cleaning pump or with tap water (minimum pressure 2 bar, max. pressure 4 bar) with an (optional) solenoid
valve.
If you clean with pond water the water loss should be compensated (with an automatic top up system for example) to guarantee a correct
functioning system.
The cleaning process intervals are determined by the pollution in the water but the controller will automatically rinse the lter every hour
for 10 seconds.