COZY 18 Manual de instruções de instalação e utilização - Página 3

Procurar online ou descarregar pdf Manual de instruções de instalação e utilização para Fogão COZY 18. COZY 18 12 páginas. For sauna
Também para COZY 18: Manual de instalação (3 páginas)

Imprimir página

For every square meter of such wall and ceiling surface you should calculate an additional 1,2m³

volume. If the sauna walls are made of massive log, the volume must be multiplied by 1,5.

1.1. STOVE PARTS

1 - Outer frame of the heater - 5

different models

2 - Chimney pipe D114

3 - Heater body

4 - Upper cleaning hole

5- Cleaning hatch

6 – Heater door with glass

7 - Ash box

8 - Combustion chamber extension -

model TW

9 – Hearth frame (only TW is not

included)

10 - Stove stones (not included)

1.2. BURNING

The „COZY" type stoves have a special heater furnace construction separates combustion air

into three parts. Part of the air passes through the fireplace grate, second part of the

combustion air is directed through air channels to the middle part of the fire chamber and

third part of the combustion air is directed through the pipes located in the furnace ceiling to

the upper part of the fire chamber. This way, the flue gases also burn and generate heat. The

burning is cleaner and more efficient. Also the burning material ( 3.3.) and ignition method (

3.5.) significantly affect the burning efficiency and the flue gas emissions.

2. INSTRUCTIONS FOR INSTALLATION

2.1. Before Installation

Before installing the stove make sure that all safety distance requirements are fulfilled. There shall

be no electrical devices, wires or inflammable materials within the established safety distances

around the stove.

The stove is not suitable for installation in a shared flue system.

All local regulations, including those referring to national and European standards need to be

complied with when installing the appliance.

The local fire authorities in charge of approving the installations can provide more detailed

information about fire safety regulations.

2.2. Ventilation of the Sauna Room

The ventilation of the sauna room should be arranged as follows:

The fresh air inlet must be placed above the stove and outlet should be as far as possible from the

stove and near the ceiling. The stove itself circulates air effectively; the purpose of this outlet is

mainly to remove moisture from the sauna after bathing. If you have through wall (TW) model, then

is very important to have outle from opposite wall of inlet near to floor (it have o be always opened

at bathing time.)

2.3. Protecting the Floor and safety distances

A. Concrete floor without tiles. The stove can be installed on a concrete floor without any specific

safety measures, if the concrete is at least 60 mm thick. Make sure that there are no wires or water

pipes in the concrete cast below the stove.