Billi Quadra 440 Manual de instalação - Página 5
Procurar online ou descarregar pdf Manual de instalação para Cozinha & amp; Acessórios de casa de banho Billi Quadra 440. Billi Quadra 440 8 páginas. Tower dispenser
Também para Billi Quadra 440: Manual de instalação (12 páginas)
Imprimir página
Installing underbench module.
XL, XT, XR.
1. Flush Water Supply
Flush water supply pipework before installing
the underbench unit by connecting 600mm
flexible braided hose to the supply tap and
running water into a bucket. Blockages/unit
malfunction caused by debris are not covered
under warranty.
2. Install Underbench Unit
Take care to observe minimum clearances.
Ensure there is adequate access to service
the unit, taking into account the tube lengths
and space available Refer Diagram 1, page 2.
3. Connect Dispenser Tubing
and Electrical Plug
Connect all tubing and electrical plug as
shown. For Quadra Compact – refer to
Diagram 8. For Quadra 420 to 4180 – refer
17a to Diagram 9. For Quadra Plus 5, Plus
9 and Plus 15, refer to Diagram 17b and
additional instructions on the following page.
Ensure correct orientation of dispenser
power plug before insertion. Trim tubes to
correct lengths using a sharp knife or plastic
tube cutter. Do not leave excess tubing which
will sag, trapping water. Fit spring clamps
supplied to retain silicone rubber tubing to
barbed fittings.
IMPORTANT: Boiling outlet (red), vent tube
(grey) must not be kinked and must be installed
with a continual fall and no sag.
4. Connect Condenser Drain Kit
a. Drill ½ inch hole (using drill bit not
provided) into drainage point (pipe).
b. Clip white john guest fitting into sliver
hose clamp.
c. Fit hose clamp to drainage pipe, ensuring
the while john guest fitting surrounds the
hole drilled.
d. Take the drain hose connection provided
and connect the 3/8 hose into the
drain clamp.
e. Connect the 3/16 hose into the condenser
outlet on the unit and tighten the nut. (Nut
to be finger tightened only).
Quadra Compact
Flexible hose
Top View
Quadra Compact
Boiling
Power Condenser
red tube
supply black tube
Vent
Chilled
grey tube
blue tube
1/2" stop tap
(installed by plumber)
Diagram 17a
Top View
Quadra
Water
supply
Vent
Diagram 18a
grey tube
tubing cut
square
Quadra
Flexible hose
1/2" stop tap
(installed by plumber)
Diagram 17b
Power
Condenser
Water
supply
black tube
supply
Boiling
Chilled
Diagram 18b
red tube
blue tube
3/16 black tube
nut
push tubing
firmly over
shank as
shown
Diagram 19
5