Billi Sahara Plus Manual de instalação - Página 4
Procurar online ou descarregar pdf Manual de instalação para Cozinha & amp; Acessórios de casa de banho Billi Sahara Plus. Billi Sahara Plus 7 páginas.
Também para Billi Sahara Plus: Manual de instalação (8 páginas), Manual do utilizador (12 páginas)
Imprimir página
Installing
underbench module.
REMOVE THE FILTER PACKING FROM
UNDER THE FILTER CANISTER
1. Flush Water Supply
Flush water supply pipework before installing
the underbench unit by connecting 450mm
flexible braided hose to the supply tap and
running water into a bucket.
2. Install Underbench Unit
Take care to observe minimum clearances.
Ensure there is adequate access to service
the unit, taking into account the tube lenths
and space available Refer Diagram 1, page 2.
3. Connect Dispenser Tubing
and Electrical Plug
IMPORTANT: Boiling outlet (red), vent tube
(grey) tube must not be kinked and must be
installed with a continual fall and no sag
Connect all tubing and electrical plug as
shown in diagram 8a & 9a for the Sahara 310
and Diagram 8b & 9b for the Sahara & Sahara
Plus 320, 360, 3120 models.
Ensure correct orientation of dispenser
power plug before insertion. Trim tubes to
correct lengths using a sharp knife or plastic
tube cutter. Avoid leaving excess tubing which
will sag, trapping water. Fit spring clamps
supplied to retain silicone rubber tubing to
barbed fittings.
4
Sahara 310
power cord
flexible hose
Birds Eye View
dispenser
boiling
ambient
power
(red)
(blue)
cord
hot vent
(grey)
Sahara 320, 360, 3120 & Sahara Plus Models
power cord
1/2" stop tap
(installed by plumber)
Diagram 8a
Birds Eye View
water
supply
Diagram 9a
flexible hose
1/2" stop tap
(installed by plumber)
Diagram 8b
power
dispensor
ambient
supply
power
(blue)
water
cord
supply
boiling
vent
(red)
(grey)
Diagram 9b