Billi XI Slimline Font Manual de instalação - Página 5

Procurar online ou descarregar pdf Manual de instalação para Cozinha & amp; Acessórios de casa de banho Billi XI Slimline Font. Billi XI Slimline Font 8 páginas. Proud & flush mount

Imprimir página

Installation procedure.

Flush Mount

1. Marking and Drilling Holes

a. Cut out hole in bench top according to

Diagram 7a on page 6. Use appropriate

router bits to give R5.0 edges.

2. Apply thick coat of moisture primer to all

cut surfaces

3. Fitting Drain Adapter

a. Fit O-ring to Drain adapter.

b. Fit Drain adapter to tray. Insert and tighten

M5 screw, Note: Do NOT over-tighten

the screw.

c. Drain tube and elbow fitting are to

face dispenser mount hole –refer to

diagram 1 on page 2.

4. Fitting Billi Font to Benchtop

a. Install the sealing gasket around the edge

of the font tray. Refer to Diagram 2.

b. Lower the Font tray into the cut out and

insert 4 x M6 bolts, one in each corner.

c. Fit the clips and M6 Flange nuts to all 4

bolts – refer to Diagram 3.

e. Tighten nuts until rim sits flat on

benchtop. Do NOT over-tighten nuts.

5. Fit front and rear cover plates

a. Remove protective film from cover

plate set.

b. Remove bottom gasket covers and insert

into gasket grooves.

c. Remove gasket cover and insert cover

into font tray.

d. Ensure holes in rear cover plate align with

the holes in the font tray.

e. Apply pressure around edge of plate(s)

to ensure proper gasket seal.

6. Install the tap – refer to diagram 4.

a. Feed the dispenser tube and tap base into

hole in the rear of the font.

b. Feed lock mechanism components onto

the end of the dispenser tube in the

following order:

i. Washer

ii. Locking bush

iii. Locking nut.

c. Slide components into position and

tighten the locking nut.

Note: Do NOT over tighten.

7. Connect Tubing to Underbench Module

a. Connect dispenser tubing to underbench

module as per installation instructions

supplied with your unit.

8. Connect Drainage

a. Connect drainage tubing with reference

to Drainage Requirement instructions

on previous page. Drainage tube must

be installed with a continual fall along

the entire length of the tube and must be

adequately clipped and supported.

Bench

Seal between

Font and Benchtop

Diagram 2

Bench

Clip

Bench

291mm

Font tray

Bolt

Diagram 3

Plate

Gasket

Font tray

Washer

Locking Bush

Locking Nut

Diagram 4

191mm

Diagram 5