AVP Synthesizers ADS-7 Manual do utilizador - Página 6

Procurar online ou descarregar pdf Manual do utilizador para Sintetizador AVP Synthesizers ADS-7. AVP Synthesizers ADS-7 8 páginas. Analog drum synthesizer with 32 step sequencer

Imprimir página

Connecting ADS-7

Connect the power adapter, audio and MIDI cables to your ADS-7 rear connectors.

Power supply (15 VAC): Connect the included power adapter to the POWER input of ADS-7;

Audio output (6.3mm jack): insert cables with 1/4 mono jacks into the MIX OUTS or

individual outputs INDIVIDUAL OUTS jacks in order to connect the ADS-7 to a mixer or other

audio equipment;

MIDI input: connect the MIDI OUT of an external sequencer or MIDI keyboard (or another

MIDI device) to the MIDI IN jack of the ADS-7 synthesizer.

Powering on ADS-7

Press the POWER ON button. The BD indicator in the sequencer section will light up

indicating that the unit is turned on.

Sequencer section

MIDI-channel selection setting

The 1

MIDI channel is set by default in ADS-7. To change it, turn off the device then press

and hold the Start/Stop button, while continuing holding the button turn on the device,

continue holding it until the START/STOP and STEPS LEDs start flashing. The first MIDI note

received from the MIDI controller will set the MIDI channel number. After installation, one

of the LEDs (1-16) will light up indicating the selected MIDI channel (from 1 to 16). After

that, you need to Power off ADS-7 and then turn it on again to resume normal operation.

Now the set MIDI channel will be stored in the device memory.

START/STOP button

This button starts or stops the sequence playback. Sends START/STOP messages to MIDI

OUT.

Step selection button STEPS

When the sequencer is not working:

The STEPS LED indicator is lit - the first 16 steps (1-16) are selected.

The STEPS LED indicator is not lit - the following 16 steps are selected (17-32).

When the sequencer is working:

The STEPS LED indicator is lit – the first 16 steps (1-16) are played.

The STEPS LED indicator is not lit - the following 16 steps are played (17-32).

Step selection button 1-32

The 1-32 LED does not lit - only 16 steps are played (1-16 or 17-32 depending on the

selection of the STEPS button).

The LED 1-32 is lit - all 32 steps (1-32) are played back.

16 buttons STEPS

Pressing one of the step buttons switches the state of this step to on/off. If the STEPS LED is

not lit, the first 16 steps (1-16) are edited. If the STEPS LED is lit, the next 16 steps are

edited (17-32).

SOUND SELECTION button

This button selects one of the ADS-7's drum sections for editing on the sequencer. When

the TR LED is selected, the TR located on the rear is fed with the sequence you have

selected which allows you to control external sound sources (drums).