Aqua Products Splasher Manual - Página 7

Procurar online ou descarregar pdf Manual para Aspirador de piscinas Aqua Products Splasher. Aqua Products Splasher 20 páginas.

5. Slide the cleaner deflector wheel over the inner tube until located on top of the float assembly. The deflector

wheel does not align with the locating key on the main body and is able to spin freely on the top section of

the main body. (picture 5) NOTE: The deflector ring can be removed and replaced with a SPLASHER cone

to enhance performance, depending on pool shape

6. Slide the outer tube assembly down the inner tube and screw the nut into place as this will secure the

deflector wheel. (picture 6)

7. Connect sufficient lengths of cleaner hose to cover the distance from the pool skimmer box or weir to the

furthest point of your pool, plus one length. (picture 7)

8. Congratulations your SPLASHER pool cleaner is ready for installation into your pool!

HOSE ASSEMBLY

The pump must be on when you check the hose length. The hose contracts when the pump is

operating and will be longer when the pump is off.

While the cleaner is operating:

Position cleaner at the furthest point of the pool from where it's attached.

(Use a pool pole and brush to easily position the cleaner in the pool.)

2. The hose should be long enough to reach the end of the pool, plus one hose

section. (The hoses are universal hoses and fit directly into each other).

3. If there is excess hose, be sure to remove the sections from the center portion

of hose. This avoids disturbing the hose weight placement.

4. Save extra hose sections for use as needed for replacement. Always keep

extra hoses stored in a straight position.

Note: Turn pool pump off when adding or removing hose sections.

To determine correct hose balance, turn the pump off

and note the cleaner's position in the pool. Correct

Hose Balance: Cleaner seal sits flat on the pool floor

and the drive tube makes 45° angle with the pool

floor.

For maximum cleaning coverage, the hose does not

pull up or down on the unit. Adjust hose weight one

inch at a time, as needed, to achieve proper hose

balance.

In pools with both shallow and deep areas, adjust hose weights first in the deep area and then in the shallow

area.

INSTALLATION

Cleaning line installation