Aqua Pulse Spas AIRLIE LUXURY SPA Instruções - Página 2

Procurar online ou descarregar pdf Instruções para Banheira de hidromassagem Aqua Pulse Spas AIRLIE LUXURY SPA. Aqua Pulse Spas AIRLIE LUXURY SPA 5 páginas.

Imprimir página
EACH TIME THE SPA IS COMPLETELY FILLED WITH FRESH WATER
Note: Do not apply any chemicals to the spas water if there is no power supply. The spa will be fine with the water
unbalanced for a week if you are waiting for an electrician.
Add 28ml
of
Liquid Lithium
Add straight into the spas water away from the filter box and run jet 1 for 5 minutes to mix it in.
Four hours after applying the first dose of Liquid Lithium balance the pH, Alkalinity & Calcium Hardness in the water by
following the instructions listed below under the title ONCE A WEEK BALANCE THE WATER
Note: Unbalanced pH, Alkalinity & Calcium Hardness will damage your spas parts and void your spas warranty.
CHEMICAL INSTRUCTIONS
AFTER COMPLETION OF USAGE FOR THE DAY
Add 28ml
of
Liquid Lithium
in.
ONCE A WEEK CLEAN THE FILTER
Remove the filter from the spa and wash thoroughly with a garden hose, then place the filter in a bucket of cold water
and add
125ml
of
Filter Cleaner & Degreaser #9 or Filter Cleaner & Degreaser 1Litre Bottle.
the filter submerged to soak for 24 hours.
After 24hours remove the filter and wash it thoroughly and allow it to completely dry out in an area exposed to the sun
or wind.
It is recommended to purchase a spare filter and alternate between the filter each week to make the cleaning process
easier. Filters which are not cleaned weekly can cause your spa to stop cleaning & heating.
Replace your filter every twelve months, however if you are rotating between two filters this will require replacement
every two years. To order your replacement filter:
https://www.aquapulsespas.com.au/products/universal-cartridge-filter-2
ONCE A WEEK BALANCE THE WATER
Note: When balancing the water in your spa you must wait 4 hours between adding each chemical and always add the
chemical away from the filter box. Your jet 1 must be run for a minimum of 5 minutes after applying any chemical.
Note: Detergents will cause foaming in the water. To avoid foaming do not allow any body lotions or swimmers which
have been through your washing machine to enter the water. You may need to shower prior to using your spa and with
your swimmers just rinse them off and hang them out to dry to avoid introducing detergents to the spas water which
causes foaming.
Top the spas water up with at least two buckets of fresh water.
Balance
the spas water using
Use the readings you get off the test strips to balance the:
Free Chlorine, pH & Alkalinity
To Balance your Calcium Hardness, you need to take a sample of your spas water into a pool or spa store for accurate
testing. Do not use any brand of Test Strips to balance Calcium Hardness they will not be accurate enough.
HOW TO BALANCE FREE CHLORINE / LIQUID LITHIUM ideal reading is between 1-3ppm.
If your reading is
lower than 1ppm
28ml Liquid Lithium.
Add straight into the spas water away from the filter box and run jet 1 for 5 minutes to mix it in.
HOW TO BALANCE TOTAL ALKALINITY ideal reading is between 80-120ppm.
If your reading is
lower than 80ppm
Visit: www.aquapulsespas.com.au
Add straight into the spas water away from the filter box and run jet 1 for 5 minutes to mix it
3 in 1 Test Strips
raise the free chlorine / liquid lithium by adding
raise the total alkalinity by adding
Agitate the water and leave