CPflight CDU737PRO Manual - Página 2

Procurar online ou descarregar pdf Manual para Monitor CPflight CDU737PRO. CPflight CDU737PRO 2 páginas.

PMDG CONFIGURATION

To use the CDU737PRO with PMDG737ngx or PMDG737ngxu you have to

install the cpflight driver. CDU driver is located into CDU737PRO page in the

section Technical and Manual.

Please be sure to install the CPflight folder under

..\Lockheed Martin\Prepar3d Vx folder.

Once installed into CPflight folder you can find the application

CDU_COM.exe and the configuration file CDU_CPflight.ini

Into the fileCDU_CPflight.ini you have to set the assigned ip CDU address.

The CDU assign automatically in dhcp mode a free ip address of your LAN.

Please, once connected, push and hold pushed the CDU menu button until

you will see the menu window. Into this window you will find the assigned ip

address. Write this ip into CDU_CPflight.ini file in CP or FO position. Do not

modify the Port value ( default is 6000, hold this value ). Save the setting and

close the file. Refer to the paragraph CONFIGURATION MENU of this

manual

Sample of CDU_CPflight.ini file

TCPIP CAP = 192.168.1.57

TCPIP FO = 192.168.1.68

PORT = 6000

Remember also to enable the PMDG SDK adding this line at the end of the

737NGX_Options.ini or 737NGXu_Options.ini

Note that EnableDataBroadcast = 1 and EnableCDUBroadcast.0=1 must be

set to enable the CDU captain side. If you have also the FO side you need to

add also the line EnableCDUBroadcast.1=1

If you do not have the CDU FO side you no need to add this last line

Save the setting and close the file.

Sample of 737NGX_Options.ini in case both CDU are connected

[SDK]

EnableDataBroadcast = 1

EnableCDUBroadcast.0=1

EnableCDUBroadcast.1=1

CDU_COM APPLICATION

Run Prepar3d and load a PMDG flight. From CPflight folder run the

application CDU_COM.exe and select "Connect" into CDU_COM application

menu bar.

The Screen saver on the hardware will disappear and the hardware will show

the PMDG characters.

Annunciators, keyboard and monitor are now interfaced and working with

PMDG737ngx or ngxu addon.

Closing the application ( or selecting "Disconnect" into CDU_COM menu bar )

you will disconnect the hardware by the addon. The CDU will show again the

Screen Saver CPflight Logo.

Just below the CDU737 dimensions: