Avsl qtx 178.839UK Manual do utilizador - Página 3
Procurar online ou descarregar pdf Manual do utilizador para Sistema de altifalantes Avsl qtx 178.839UK. Avsl qtx 178.839UK 5 páginas. Portable pa
Control panel
Powering up
Your new QRPABT unit may arrive with you with the internal battery charged. Before connecting to the mains with the
supplied power adaptor, switch the unit on and check the POWER LED. If it is green, there is charge in the battery. If it is
red, then you will need to charge the battery before using away from a mains supply
Connect the QRPABT unit to the mains using the supplied power adaptor. You may otherwise opt to connect the DC input
jack to an external 12-15Vdc supply, such as a car battery, or use the internal battery if charged.
When not in use but connected to the mains, if the POWER switch is in the
charged from the mains supply. This can be observed by the CHARGE LED which will light orange when charging. When
fully charged, the CHARGE LED will change to green.
Note: it is recommended to store the PA unit at an ambient temperature and not with the battery fully discharged.
Initial setup
Turn all VOLUME & ECHO controls down (anti-clockwise) and turn the POWER switch on (the power LED should light).
BASS and TREBLE controls should remain pointing vertically (12-o-clock position). Turn up the main VOLUME control part
way and switch VCV off. Your QRPABT unit should now be ready to operate.
VHF Microphone
Insert the supplied AA batteries into the handheld microphone by carefully unscrewing the base and connecting the "+"
and "-" terminals or the battery to the corresponding contacts inside the microphone body, taking care to observe the
correct polarity.
Turn the VHF VOL control up (clockwise) part way.
Switch on the wireless mic – the RF LED should light as a result. If the LED on the transmitter lights dimly, change the
battery. Gradually increase the VHF VOL control, testing the microphone for output through the speaker. Take care not to
incur "feedback" (howling or screeching sound through the speaker) by keeping the microphone a sensible distance from
the speaker and pointing away from the speaker so that it doesn't
Turning the ECHO control clockwise introduces a pre-set echo function for singing and special effects. BASS and TREBLE
can be cut by turning anti-clockwise or boosted by turning clockwise.
When not in use, switch the beltpack transmitter off and remove the batteries if not being used for long periods.
1
USB port
2
SD/MMC card slot
3
ECHO level
4
Wired MIC / guitar volume
5
TREBLE EQ
6
VHF Mic volume
7
LINE IN 2 x RCA
8
VCV talkover on/off
9
Wired MIC.1 / guitar input 6.3mm jack
10
Wired MIC.2 input 6.3mm jack
11
Smart phone / aux input stereo 3.5mm jack
12
DC power input jack
13
Media player LCD display & IR receiver
14
Media player mode & transport controls
15
BASS EQ
16
Main volume
17
VHF wireless receiver on/off
18
MIX OUT line output 2 x RCA
19
Power on/off
20
Fuse holder
21
Battery charge & power LEDs
off
position, the internal battery will be re-
hear
the speaker output.
178.838UK, 178.839UK User Manual