Allied Telesis AT-x230-10GP Manual de instalação - Página 9
Procurar online ou descarregar pdf Manual de instalação para Router de rede Allied Telesis AT-x230-10GP. Allied Telesis AT-x230-10GP 14 páginas. Rack mount installation guide
Imprimir página
Installing a device in an equipment rack
Before installing
the device
AT-x230-10GP, AT-AR3050S and AT-AR4050S Rack Mount Installation Guide
Observe the following requirements before installing your device in an
equipment rack:
Verify that the rack is safely secured and will not tip over. Devices
in a rack should be installed starting at the bottom, with the heavier
devices near the bottom of the rack.
Ensure that there is a power outlet for the switch that is close to the
device and is easily accessible.
Ensure that the position of the device in the rack will provide easy
access to the device's ports. This will make it easier to connect and
disconnect cables, as well as view the device's LEDs.
Verify that the air flow around the device and through its vents on
the side and rear will not be restricted, so that the device can
maintain adequate cooling.
Do not place objects on top of the device.
Do not expose the device to moisture or water.
Ensure that the rack is in a dust-free environment.
Be sure to use dedicated power circuits or power conditioners to
supply reliable electrical power to the network devices.
Note
This product is non-compatible with L-shaped connector power
cable (AT-PWRCBL-J01L/J01R).
9