Allied Telesis Rapier Series Manual de resolução de problemas
Procurar online ou descarregar pdf Manual de resolução de problemas para Router de rede Allied Telesis Rapier Series. Allied Telesis Rapier Series 8 páginas. How to set up pppoe between a linux client and access concentrator
Também para Allied Telesis Rapier Series: Resolução de problemas (5 páginas), Nota de lançamento (8 páginas), Como configurar (9 páginas), Como fazer (8 páginas)
Imprimir página
How To |
Troubleshoot ISDN Connections
Introduction
Ideally, setting up an ISDN connection is very much a straightforward process:
Connect the router to the ISDN network interface.
Configure ISDN call definitions on the router. See How To Configure ISDN Calls On Allied
Telesis Routers, available from www.alliedtelesis.com/resources/literature/howto.aspx.
Send traffic.
However, for one reason or another, there are occasions when the setup process is not as
smooth as it should be.
So if you have set up your router to communicate over ISDN, but the setup does not appear
to be working, this How To Note contains some steps you can take to try and resolve the
problem.
Which products does it apply to?
This configuration applies to the following Allied Telesis routers and switches, when a BRI or
PRI interface is installed in the base unit or through a PIC:
AR300 series routers
AR400 series routers
AR700 series routers
Rapier series switches
Rapier i series switches
Related How To Notes
You also may find the following How To Notes useful:
How To Configure ISDN Calls On Allied Telesis Routers
How To Configure Common ISDN Access Concentration With The Firewall
How To Notes are available from www.alliedtelesis.com/resources/literature/howto.aspx.
C613-16030-00 REV B
www.alliedtelesis.com