Dell 510D Manual de serviço - Página 10

Procurar online ou descarregar pdf Manual de serviço para Computador portátil Dell 510D. Dell 510D 43 páginas. Service manual

Back to Contents Page

Microprocessor Module

Dell™ Latitude™ D510 Service Manual

Removing the Microprocessor Module

Installing the Microprocessor Module

Removing the Microprocessor Module

CAUTION:

Before performing the following procedures, read the safety instructions in your Product Information Guide.

NOTICE:

To prevent damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's

electronic components. You can do so by touching an unpainted metal surface.

NOTICE:

Do not touch the processor die. Press and hold the microprocessor down on the substrate on which the die is mounted while turning the cam

screw to prevent intermittent contact between the cam screw and microprocessor.

NOTICE:

To avoid damage to the microprocessor, hold the screwdriver so that it is perpendicular to the microprocessor when turning the cam screw.

1. Follow the instructions in

"Preparing to Work Inside Your

2. Remove the keyboard.

NOTICE:

To ensure maximum cooling for the microprocessor, do not touch the heat transfer areas on the microprocessor thermal-cooling assembly. The

oils in your skin reduce the heat transfer capability of the thermal pads.

3. Remove the

microprocessor thermal-cooling

NOTICE:

When removing the microprocessor module, pull the module straight up. Be careful not to bend the pins on the microprocessor module.

4. Use a small, flat-blade screwdriver to rotate the ZIF-socket cam screw counterclockwise until it comes to the cam stop.

1 ZIF socket cam screw

2 pin-1 corner

NOTE:

The ZIF-socket cam screw secures the microprocessor to the system board. Take note of the arrow on the ZIF-socket cam screw.

5. Lift out the microprocessor module.

Installing the Microprocessor Module

NOTICE:

Ensure that the cam lock is in the fully open position before seating the microprocessor module. Seating the microprocessor module properly in

the ZIF socket does not require force.

Computer."

assembly.