Allied Telesis AT-IMC100T/SCMM Manual de instalação - Página 11
Procurar online ou descarregar pdf Manual de instalação para Conversor de multimédia Allied Telesis AT-IMC100T/SCMM. Allied Telesis AT-IMC100T/SCMM 20 páginas. Fast ethernet industrial media converter
Imprimir página
Hardware Description
Table 2-1: Definition of LED indicators
LED
Color
LNK/ACT for Fiber
Green
100M for RJ-45
Amber
LNK/ACT for RJ-45
Green
2.6 DIP-Switch
Table 2-2: DIP-Switch Status Description
S/W No
Status
1
On
Off
2
On
Off
3
On
Off
4
On
Off
Link Lose Forwarding (DIP-Switch 2): When LLF enabled, it allows UTP link failures to be reported to the fiber side and
also allows Fiber link failures to be reported to the UTP side. Therefore, a link fault pass-through feature is provided in both
UTP and Fiber side.
Media mode (DIP-Switch 4): When media mode is enabled (ON), it operates with the minimum latency. The transmis-
sion flow does not wait until entire frame is ready, but instead it forwards the received data immediately after the data being
received. And TP port should be forced at 100M in this application. When DIP-Switch is in switching mode (OFF), the con-
verter function is the same as a Switch Hub.
Note:
Please don't change the DIP-switch setting when UTP or fiber port is transmitting or receiving data. It may cause
some data error. Besides, if you change the DIP-switch setting, please power off the converter and power on again to
make the setting effective.
AT-IMC100T/SCSM and AT-IMC100T/SCMM Fast Ethernet Industrial Media Converters
Description
On
Connected to network
Blink
Networking is active
Off
Not connected to network
On
Link to 100Mbps network
Blink
---
Off
Link to 10Mbps network
On
Connected to network
Blink
Networking is active
Off
Not connected to network
Description
Enables Port/Power Alarm
Disables Port/Power Alarm
Enables LLF
Disables LLF
100Base-FX Half-mode
100Base-FX Full-mode
Media mode (100TX to 100FX)
Switching mode
DIP-Switch
11