Allied Telesis AR400 Series Manual de instalação rápida - Página 5

Procurar online ou descarregar pdf Manual de instalação rápida para Hardware de rede Allied Telesis AR400 Series. Allied Telesis AR400 Series 8 páginas. How to set up pppoe between a linux client and access concentrator
Também para Allied Telesis AR400 Series: Como configurar (6 páginas), Manual de resolução de problemas (8 páginas), Resolução de problemas (5 páginas), Manual de instalação rápida (12 páginas), Manual de informações de segurança (18 páginas), Como fazer (8 páginas)

Imprimir página

Allied Telesis AR400 Series Manual de instalação rápida

Quick Install Guide

Figure 1: Rear panel of an AR410, showing the AC power inlet, power switch, console port, Ethernet ports, and

an optional PIC card.

POWER

AC Power Inlet

AC Power Switch

C613-04032-01 REV C

Check the supply voltage and the router's rated voltage.

AR400 Series routers are fitted with a universal mains power supply that

will function over the range 100-240 VAC and 50–60Hz.

The specific power supply requirements for a particular model are clearly

displayed on the rear or underside of the router. If the supply is outside the

accepted range for the router, the router may not operate and damage to the

router may result.

Apply power to the router.

Fit the power cord retaining clip to the AC power inlet on the router's rear

panel.

Plug the power cord into the AC power inlet and check that the power

switch is in the ON position (see Figure 1 on page -5). The Power LED and

System LED will light briefly.

If the power LED fails to light, or the System LED lights continuously, refer

to the troubleshooting section later in this guide.

ETH0

10BASE-T/100BASE-TX SWITCH PORTS

X PC

= HUB

10/100 Switch Ports

ETH 0

Connect the data cables.

Make sure that each cable connection is secure.

Initiate router start-up.

Using the terminal cable supplied, connect a VT100-compatible terminal,

or the COM port of a PC running a terminal emulation program such as

Windows Terminal, to the Console RS-232 (ASYN 0) port on the router's

rear panel.

Set the communication parameters on your terminal or terminal emulation

program to:

•

Baud rate: 9600

•

Data bits: 8

•

Parity: None

•

Stop bits: 1

•

Flow control: Hardware

See the AR Router Hardware Reference for more information on configuring

emulation software.

PIC BAY0

CONSOLE RS-232

ASYN0

Console Port

PIC Bay (with optional

AT-AR023 SYN PIC)

SYN