Dell PowerEdge 1550 Manual de instalação - Página 4

Procurar online ou descarregar pdf Manual de instalação para Computador portátil Dell PowerEdge 1550. Dell PowerEdge 1550 6 páginas. Wake-on-lan (wol) support on dell servers
Também para Dell PowerEdge 1550: Manual de instalação (3 páginas), Atualização da informação (12 páginas), Manual de instalação (24 páginas), Informações sobre a configuração e as características (9 páginas), Manual (15 páginas), Manual do utilizador (34 páginas)

Imprimir página
Dell PowerEdge 1550 Manual de instalação
riser board
1-2
Five-Volt Riser Board Installation
Figure 1-1. Riser Board Removal
6.
Lift the riser board up and away from the chassis (see Figure 1-1).
5V Riser Board Installation
Lower the 5V riser board into connector PCI2 on the system board, making sure that
the riser board is fully seated in the connector.
The 5V riser board contains a single 64-bit, 33-MHz PCI expansion-card connector.
NOTE: Connector PCI1 supports a single short 64-bit, 66-MHz expansion card in its
fixed socket on the system board.
Expansion-Card Installation
To install an expansion card on the 5V riser board, perform the following steps.
NOTICE: Full-length 5V PCI cards can be installed only in connector PCI2
via the 5V riser board. When a full-length card is in this connector, a
secondary microprocessor cannot occupy the PROCESSOR2 socket. A
terminator module must occupy the PROCESSOR2 socket.
NOTE: If the system is mounted high in the rack, you may find it easier to completely
remove the system from the rack before performing this procedure.
1.
Shut down the system and turn off power to the system.
2.
Disconnect the power cable from the back of the system chassis.
connector PCI2