Dell XPS 430 Manual de serviço - Página 2
Procurar online ou descarregar pdf Manual de serviço para Ambiente de trabalho Dell XPS 430. Dell XPS 430 42 páginas. Dell xps computer setup
Também para Dell XPS 430: Configuração (2 páginas)
Imprimir página
Back to Contents Page
Replacing the Battery
Dell™ XPS™ 430 Service Manual
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
A new battery can explode if it is incorrectly installed. Replace the battery only with the same or equivalent type recommended by the
manufacturer. Discard used batteries according to the manufacturer's instructions.
To replace the battery:
1. Enter the system setup program and record the values for all the screens (see
installing the new battery.
2. Follow the procedures in
Before You
3. Remove the computer cover (see
4. Locate the battery socket (see
NOTICE:
If you pry the battery out of its socket with a blunt object, be careful not to touch the system board with the object. Ensure that the object is
inserted between the battery and the socket before you attempt to pry out the battery. Otherwise, you may damage the system board by prying off
the socket or by breaking circuit traces on the system board.
5. Remove the battery by carefully prying it out of its socket with your fingers or with a blunt, nonconducting object, such as a plastic screwdriver.
6. Insert the new battery into the socket with the side labeled "+" facing up, and then snap the battery into place.
7. Replace the computer cover. (see
1
coin-cell battery
8. Connect your computer and devices to electrical outlets, and then turn them on.
9. Enter system setup and restore the settings you recorded in
10. Properly dispose of the old battery. See the safety instructions that shipped with your computer for battery disposal information.
Back to Contents Page
Begin.
Removing the Computer
Cover).
System Board
Components).
Replacing the Computer
Cover).
2
tab
3
battery socket
step 1
Entering System
Setup) so that you can restore the correct settings after
(see
Entering System
Setup).