Chris King Classic Manual - Página 10

Procurar online ou descarregar pdf Manual para Acessórios para bicicletas Chris King Classic. Chris King Classic 20 páginas. Hub

Disassembly of one piece axle on front BMX hub

helper

2.5mm

Hex Bolt

1. Insert a 2.5mm hex wrench into the adjusting clamp hex bolt, and loosen. If adjusting

clamp is diffi cult to remove, insert a 2.5mm hex key into "helper hole" on adjusting clamp

adjacent to 2.5mm hex bolt. Use the hex key as a lever to unscrew adjusting clamp.

2. With adjusting clamp facing towards you, hold opposite end of axle stationary, and rotate

clamp in a counter clockwise direction. After one complete revolution the adjusting clamp

should be free from the axle.

3. Slide out axle.

4. Both hub shell bearing assemblies can now be accessed.

For bearing service information see "Service of the bearings", page 13.

1. Lightly grease threads on axle.

2. Insert driveshell into the hub shell; turn in a clockwise motion while letting it pull itself in.

A distinctive click sound will indicate that the driveshell is fi rmly seated.

3. Insert main axle into hubshell until axle is through the hub.

4. Thread adjusting clamp onto the protruding threads of axle.

5. Snug the adjusting clamp up to the bearing.

6. Proceed to "Adjustment of one piece axle on front BMX hub", below.

The one piece front axle assembly features an adjusting clamp that minimizes over tightening or over pre-

loading of the bearings. Adjustment may be accomplished while axle is attached to bicycle frame.

1. Loosen the adjusting clamp hex bolt using a 2.5mm hex wrench.

2. Hand tighten the adjusting clamp onto the axle until it stops against the bearing. If adjusting

clamp is diffi cult to move, insert a 2.5mm hex wrench into "helper hole" on adjusting clamp

adjacent to 2.5mm hex bolt. Use the hex key as a lever to turn adjusting clamp.

3. Once the adjusting clamp is in position, use a 2.5mm hex wrench to tighten the adjusting

clamp hex bolt to 10 inch-pounds.

4. Check for play or binding and readjust if needed.

If you have any additional questions, please contact our Technical Service Department at 800-523-

6008, or check out our website for tech info and videos: www.chrisking.com

hole

Front Classic

Adjusting

Hubshell Assembly

Clamp

Front BMX Axle

Assembly

Figure 7

(see fi gure 7)

2.5mm

hex bo

(see fi gure 7)