Dell E45S003 Manual de referência - Página 12

Procurar online ou descarregar pdf Manual de referência para Servidor Dell E45S003. Dell E45S003 23 páginas.

Steps

1. On the System Setup Main Menu screen, click System BIOS > Boot Settings > UEFI Boot Settings > UEFI Boot

Sequence.

2. Use the arrow keys to select a boot device, and use the plus (+) and minus (-) sign keys to move the device down or up in

the order.

3. Click Exit, and then click Yes to save the settings on exit.

NOTE:

You can also enable or disable boot order devices as needed.

Network Settings

To view the Network Settings screen, power on the system, press F2, and click System Setup Main Menu > System BIOS

> Network Settings.

NOTE:

For information about Linux network performance settings, see the Linux Network Tuning Guide for AMD EPYC

Processor Based Servers at AMD.com.

NOTE:

Network Settings are not supported in BIOS boot mode.

Table 12. Network Settings details

Option

UEFI PXE Settings

PXE Device n (n = 1 to 4)

PXE Device n Settings(n = 1 to 4)

UEFI HTTP Settings

HTTP Device n (n = 1 to 4)

HTTP Device n Settings (n = 1 to 4)

UEFI iSCSI Settings

Table 13. PXE Device n Settings details

Option

Interface

Protocol

Vlan

Vlan ID

Vlan Priority

Table 14. HTTP Device n Settings details

Option

Interface

Protocol

Pre-operating system management applications

Description

Enables you to control the configuration of the UEFI PXE device.

Enables or disables the device. When enabled, a UEFI PXE boot option is

created for the device.

Enables you to control the configuration of the PXE device.

Enables you to control the configuration of the UEFI HTTP device.

Enables or disables the device. When enabled, a UEFI HTTP boot option is

created for the device.

Enables you to control the configuration of the HTTP device.

Enables you to control the configuration of the iSCSI device.

Description

Specifies NIC interface used for the PXE device.

Specifies Protocol used for PXE device. This option is set to IPv4 or IPv6. This option is set to

IPv4 by default.

Enables Vlan for PXE device. This option is set to Enable or Disable. This option is set to

Disable by default.

Shows the Vlan ID for the PXE device

Shows the Vlan Priority for the PXE device.

Description

Specifies NIC interface used for the HTTP device.

Specifies Protocol used for HTTP device. This option is set to IPv4 or IPv6. This option is set

to IPv4 by default.

The following options will be available when Protocol is set as IPv6:

Auto Configuration: IPv6 Auto Configuration Enable/Disabled for this HTTP Device.

IPv6 Address: IPv6 Unicast address for this HTTP Device.