Dell E665 Manual de instalação e serviço - Página 12
Procurar online ou descarregar pdf Manual de instalação e serviço para Servidor Dell E665. Dell E665 23 páginas. Emc vxrail appliances on poweredge servers
Também para Dell E665: Manual do Proprietário (37 páginas)
Imprimir página
Item
Ports, panels, or slots
6
Power supply unit (PSU
1)
7
Power supply unit (PSU
2)
8
LOM Riser Ethernet port
(slot 1)
9
USB 3.0 port (2)
10
VGA port
11
System status indicator
cable port
12
System identification
button
For more information about the ports and connectors, see the Dell VxRail™ E665, E665F, and E665N Technical Specifications.
NIC indicator codes
Each NIC on the back of the system has indicators that provide information about the activity and link status. The activity LED
indicator indicates if data is flowing through the NIC, and the link LED indicator indicates the speed of the connected network.
1. Link LED indicator
2. Activity LED indicator
The following table describes the different NIC indicator codes and condition of the connectivity:
Status
Link and activity indicators are off.
Link indicator is green, and activity indicator
is blinking green.
Link indicator is amber, and activity
indicator is blinking green.
12
System overview
Icon
Description
N/A
For more information about the PSU configurations, see the Dell
VxRail™ E665, E665F, and E665N Technical Specifications.
N/A
For more information about the PSU configurations, see the Dell
VxRail™ E665, E665F, and E665N Technical Specifications.
N/A
Use the NIC ports that are integrated on the LOM riser for
network connectivity. The LOM riser contains the OCP network
card.
For more information about the supported configurations, see the
Dell VxRail™ E665, E665F, and E665N Technical Specifications.
Use the USB 3.0 port to connect USB devices to the system.
Use the VGA port to connect a display to the system. For
more information, see the Dell VxRail™ E665, E665F, and E665N
Technical Specifications.
N/A
Enables you to connect the status indicator cable and view system
status when the CMA is installed.
Press the system ID button:
● To locate a particular system within a rack.
● To turn the system ID on or off.
To reset iDRAC, press and hold the button for 16 seconds.
NOTE:
● To reset iDRAC using system ID, ensure that the system ID
● If the system stops responding during POST, press and hold
Condition
The NIC is not connected to the network.
The NIC is connected to a valid network at its maximum port speed, and data is
being sent or received.
The NIC is connected to a valid network at less than its maximum port speed,
and data is being sent or received.
button is enabled in the iDRAC setup.
the system ID button (for more than five seconds) to enter
the BIOS progress mode.