Dell EMC VxFlex Ready Node 14G Manual de Inspeção - Página 3
Procurar online ou descarregar pdf Manual de Inspeção para Servidor Dell EMC VxFlex Ready Node 14G. Dell EMC VxFlex Ready Node 14G 8 páginas.
Também para Dell EMC VxFlex Ready Node 14G: Manual de início rápido (22 páginas)
Imprimir página
Introduction
Monospace
Used for:
l
l
l
l
Monospace italic
Used for variables
Monospace bold
Used for user input
[ ]
Square brackets enclose optional values
|
Vertical bar indicates alternate selections - the bar means "or"
{ }
Braces enclose content that the user must specify, such as x or y or
z
...
Ellipses indicate nonessential information omitted from the example
Where to get help
Dell EMC support, product, and licensing information can be obtained as follows:
Product information
For documentation, release notes, software updates, or information about Dell
EMC products, go to Dell EMC Online Support at https://support.emc.com.
Technical support
Go to Dell EMC Online Support and click Service Center. You will see several
options for contacting Dell EMC Technical Support. Note that to open a service
request, you must have a valid support agreement. Contact your Dell EMC sales
representative for details about obtaining a valid support agreement or with
questions about your account.
Your comments
Your suggestions will help us continue to improve the accuracy, organization, and
overall quality of the user publications. Send your opinions of this document to
This document provides an overview of the inspection process for VxFlex Ready Node
servers.
When the node is powered on, the front panel blue LED should light up and be steady.
In addition, neither the power supplies nor drives should have any amber LEDs lit.
If the front panel LEDs are either blinking or colored amber, or if the drives light up an
amber LED, use the information in the following sections to check the nodes. The
sensor information and the Event log information are available via the BMC. You can
access the information on the drives from the PERCCLI utility.
Before you begin, ensure that you know the IP address of the BMC (iDRAC) port on
the server.
Perform the following steps to inspect a server:
Check the hardware installation.
l
System code
System output, such as an error message or script
Pathnames, filenames, prompts, and syntax
Commands and options
Server Inspection Guide
Introduction
3