Dell Force10 S2410 Manual de início rápido - Página 18

Procurar online ou descarregar pdf Manual de início rápido para Servidor Dell Force10 S2410. Dell Force10 S2410 31 páginas. Installing the s2410 system
Também para Dell Force10 S2410: Manual (42 páginas)

Imprimir página

Step

Task

Set your initial console terminal settings to match the default console settings on

the switch:

9600 baud rate

No parity

8 data bits

1 stop bit

No flow control (console port only)

After establishing a connection, you can modify the settings to match at each

end of the connection.

If you use the console port to download software to the switch, you will

probably want to raise the console baud rate. Establish a connection with the

default settings to verify the connection. Then use the lineconfig command to

access the Line Config mode, and use the serial baudrate command to raise the

baud rate on the console port. (Match the settings in your terminal access

program.)

Accessing the RJ-45 Console Port with a DB-9 Adapter

You can connect to the console using an RJ-45 to DB-9 adapter along with the

RJ-45 rollover cable if the DTE has a DB-9 interface. Table 2-1 lists the pin

assignments.

Table 2-1. Pin Assignments Between the Console and a DTE Terminal Server

Console Port

RJ-45 to DB-9

Signal

Port Pinout

DTR

TxD

GND

RxD

DSR

Installing the Software

Adapter