Dell Force10 S2410 Manual de início rápido - Página 26

Procurar online ou descarregar pdf Manual de início rápido para Servidor Dell Force10 S2410. Dell Force10 S2410 31 páginas. Installing the s2410 system
Também para Dell Force10 S2410: Manual (42 páginas)

Imprimir página

Step Task

To add tagged ports to the

VLAN, specify a single port in

unit/slot/port format to add to

the selected VLAN, or specify a

sequential port range as unit/

slot/port-unit/slot/port.

Specify a non-sequential port

range as unit/slot/port,

unit/slot/port,... Specify a LAG

ID as an integer (List LAG IDs

with show interface port-channel

brief.)

To add untagged ports to the

VLAN, specify either a port,

port range, port channel, or port

channel range, as described

above.

(OPTIONAL) Name the VLAN. name VLAN-name

Verify the configuration.

NOTE: Enable each port added to the VLAN.

Assign Interfaces to a VLAN

Executing the interface vlan command (Global Config mode) either creates a

VLAN or selects a previously created VLAN and then enters the Interface

VLAN mode, where you have access to commands that configure the selected

VLAN.

Assign an IP Address to a VLAN

You must have the optional SFTOS Layer 3 Package installed to

NOTE:

configure routing commands and to set IP addressing an interface. Refer to

the SFTOS Configuration Guide for information on implementing the

Layer 3 capabilities.

Installing the Software

Command Syntax

[no] tagged unit/slot/port

[no] untagged

unit/slot/port

show vlan id vlanid

Command Mode

Interface VLAN

Privileged Exec