Dell PowerEdge 1750 Manual de início rápido - Página 3
Procurar online ou descarregar pdf Manual de início rápido para Servidor Dell PowerEdge 1750. Dell PowerEdge 1750 3 páginas. Systems
Também para Dell PowerEdge 1750: Manual (15 páginas), Ficha de dados (2 páginas), Manual do utilizador (34 páginas)
Imprimir página
Removing a ROMB Card
CAUTION:
Before you perform this procedure, you must turn off the system and
disconnect it from its power source. For more information, see
You and Your
System" in "Troubleshooting Your System."
CAUTION:
Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. See your System
Information Guide for complete information about safety precautions, working
inside the computer, and protecting against electrostatic discharge.
NOTICE:
To avoid possible data loss, back up all data on the hard drives before changing
the mode of operation of the integrated SCSI controller from SCSI to RAID.
1. Turn off the system, including any attached peripherals, and disconnect the system
from the electrical outlet.
2. Open the system covers. See
System."
3. If a PCI card is installed over the ROMB card, remove the PCI card. See
Expansion
Card."
4. Pull the ROMB card up out of the four standoffs. See
5. Disconnect the ROMB backup battery from the backup battery connector, and pull the
battery assembly up out of the two standoffs. See
6. Close the system covers. See
System."
"Opening the System
Figure
"Closing the System
Covers" in "Troubleshooting Your
"Safety First—For
Covers" in "Troubleshooting Your
"Removing an
Figure
6-11.
6-11.