DH Lifelabs AquaSolvo AAHE-50WC04 Manual de instruções - Página 6
Procurar online ou descarregar pdf Manual de instruções para Equipamento de laboratório DH Lifelabs AquaSolvo AAHE-50WC04. DH Lifelabs AquaSolvo AAHE-50WC04 10 páginas. Eco ambient air sterilizer
Também para DH Lifelabs AquaSolvo AAHE-50WC04: Manual de instruções (10 páginas)
Imprimir página
Operation Instructions
The Control Panel
Operation of the unit is controlled by buttons on the Control Panel as shown in Figure 2.
Figure 2. Control Panel
Icon
Description
Power ON/OFF Button .
Controls operation of the unit. Pressing the button turns the unit
ON or OFF. Any time the unit is turned on in the future it will
start up same operating mode it was in when last operated.
Sterilize Button .
The light remains on when the machine is on and flash when
electrolysis is working to process HOCl.
You can turn the sterilization function off, then it will work as a
purifier.
Sleep Mode Button .
Press this button to place the unit in sleep mode. In sleep mode
the fan runs at ultra-low speed for silence, and the light ring
turns off.
Fan Speed Button .
Use this button to adjust the fan speed, toggling through the
1-2-3 fan speeds. An indicator corresponding to the selected fan
speed will illuminate. When the unit is in Sleep mode, pressing
this button will cancel Sleep mode.
Salt Level Indicator .
When the salt level is too high, the Indicator will flash green
with sound alert, pls follow the operating alerts in page 9 for the
operation action.
When the salt level is too low, the indicator will display green
with sound alert, pls follow the operating alerts in page 9 for the
operation action.
7
Water Level Indicator .
When the water level is too low, the indicator will display blue
with sound alert, pls follow the operating alerts in page 9 for the
operation action.
Timer Button .
Allows you to select how long the machine will run before
it automatically shuts off. Press the icon toggle through the
options (2H-4H-8H-None). Once selected, an internal timer
controls operation of the unit for the selected duration. Once
the timer expires, the unit shuts down and enters the standby
mode. Do not use this option if you want the unit to run
continuously.
Filter Replacement Indicator/Button .
Yellow 1 indicator illuminated: Replace Cold Evaporation Filter
Red 2 indicator illuminated: Replace 4-in-1 HEPA Filter
After replacing the filter, press and hold this button for 3 seconds
to reset the filter life countdown.
The inner light ring around the control panel .
Works and indicates the indoor air quality as monitored by the PM2.5 sensor:
Blue: Air Quality Good
Yellow: Air Quality Moderate
Red: Air Quality Poor
8