Dell PowerEdge 4400 Manual de instalação - Página 7

Procurar online ou descarregar pdf Manual de instalação para Servidor Dell PowerEdge 4400. Dell PowerEdge 4400 36 páginas. Wake-on-lan (wol) support on dell servers
Também para Dell PowerEdge 4400: Manual de instalação (42 páginas), Manual de instalação (20 páginas), Manual de instalação (28 páginas), Instalação do bastidor (37 páginas), Manual de atualização (8 páginas), Atualização da informação (8 páginas), Manual do utilizador (42 páginas), Instalação do bastidor (34 páginas), Manual de instalação do hardware (40 páginas), Manual (15 páginas)

support.dell.com

7 .

Attach the locking bar to the front of the drive bay assembly.

Insert the bottom end of the locking bar (the end without the screw hole)

into the slot at the bottom-front of the assembly.

Pivot the locking bar up so that the recessed hole at the top of the bar aligns

with the screw hole at the top of the assembly, and secure the locking bar

with the flush-mount screw.

Installing the External Drive Bay

To install the external drive bay, use the following procedure:

Shut down the system, turn off the computer and any attached peripherals, and

disconnect the computer and peripherals from their electrical outlets.

Remove the computer cover and front bezel.

See the Installation and Troubleshooting Guide for instructions on removing the

computer cover and front bezel.

Slide the drive bay assembly into the external drive bay until it snaps into place.

NOTE: Step 4 describes one configuration for SCSI drives installed in the external

drive bay. For other configurations, see the Installation and Troubleshooting Guide.

Attach the two connectors on the terminator end of the SCSI cable to the two

SCSI connectors on the back of the drive bay assembly, and attach the connector

on the other end of the cable to either the PRIMARY SCSI-A or PRIMARY SCSI-B

connector on the system board (see Figure 1-2).

Dell PowerEdge Systems — Installing the External Drive Bay

1-3