DH Lifelabs Aaira + HEPA AAHE-50WH04C Manual de instruções - Página 7

Procurar online ou descarregar pdf Manual de instruções para Humedecer DH Lifelabs Aaira + HEPA AAHE-50WH04C. DH Lifelabs Aaira + HEPA AAHE-50WH04C 10 páginas.

Imprimir página

Filter Replacement

Cold Evaporation Filter Replacement

The cold evaporation filter should be replaced every 6 months, or whenever indicated by

the yellow 1 illuminated on the Filter Replacement Indicator on the Control Panel.

Remove the top cover from the back of the device.

Grasp the handle of the HOCl generator and turn it to the right to release it from

the base.

Remove the HOCl generator.

NOTE: Handle the Cold evaporation filter by the end caps to avoid touching

the Cold evaporation filter and preventing possible contamination of the

filter element.

Unscrew the cold evaporation filter from the generator and discard.

Remove the replacement cold evaporation filter from packaging and screw it into

the inner bottom of the HOCl generator.

Replace the HOCl generator in the Purifier and turn the handle to the left to lock it

into place on the base.

Turn on the purifier. After replacing the filter, press and hold the Filter Replacement

Indicator for 3 seconds to reset the filter life countdown.

NOTE: If you replace the filter before the accumulated life time is reached, the

filter life timer cannot be reset.

H13 True HEPA Filter Replacement

The filter should be replaced every 12 months or whenever indicated by the red 2

illuminated on the Filter Replacement Indicator on the Control Panel. However this

interval is intended as a guideline only. In environments with a high concentration of

contaminants such as dust, pet dander, or cigarette/cigar smoke you may need to replace

the filter more frequently.

NOTE: The HEPA filter is not washable. DO NOT immerse it in water.

Make sure the device is OFF and unplugged.

NOTE: If you have difficulty removing the bottom cover, remove the top cover

prior to removing bottom cover.

Detach and remove the magnetic bottom cover from the unit.

Remove using the pull tabs and replace the replacement filter into the device.

NOTE: Ensure that the pull tabs are facing outward to facilitate filter removal later.

Inspect the screen on the bottom cover and if necessary clean any excess dust or dirt

from the screen using a hand held vacuum.

Replace the bottom cover by placing the bottom cover into the slots on the device.

Gently push the top of the bottom cover into place.

Turn on and hold the Filter Replacement Indicatot for 3 seconds to reset the filter life

countdown.

Cleaning and Maintenance

When the device is not used for an extended time, store it in

a cool dry place. Do not store the device where it might be

exposed to excess moisture or direct sunlight. The device

may not operate effectively in very low temperatures. The

device can be damaged when exposed to sub-freezing

temperatures. Use a dry cloth to clean the exterior of the

device. Do not use any chemicals or cleaners.

Cleaning the Air Quality Sensor

The inlet for the air quality sensor is located at the back of the

machine. Every 2 months you should clean the inlet using a

vacuum or with a cotton swab that has been lightly moistened

with clean water.

AIR QUALITY SENSOR