Dell VEP4600 Manual de instalação - Página 18

Procurar online ou descarregar pdf Manual de instalação para Servidor Dell VEP4600. Dell VEP4600 40 páginas.
Também para Dell VEP4600: Manual de configuração (23 páginas), Manual de instalação (40 páginas)

Imprimir página

Rack or cabinet hardware installation

You may either place the platform on a rack shelf or mount the platform directly into a 19" wide, EIA-310- E-compliant rack.

The platform includes two-post rail assemblies.

WARNING:

This document is a condensed reference. Read the safety instructions in your Safety,

Environmental, and Regulatory information booklet before you begin.

NOTE:

The illustrations in this document are not intended to represent a specific platform.

NOTE:

Do not the use the mounted two-post rails as a shelf or a workplace.

Rack mount safety considerations

● Rack loading—Overloading or uneven loading of racks may result in shelf or rack failure, possibly damaging the equipment

and causing personal injury. Stabilize racks in a permanent location before loading begins. Mount the components starting at

the bottom of the rack, then work to the top. Do not exceed your rack's load rating.

● Power considerations—Connect only to the power source specified on the unit. When you install multiple electrical

components in a rack, ensure that the total component power ratings do not exceed the circuit capabilities. Overloaded

power sources and extension cords present fire and shock hazards.

● Elevated ambient temperature—If installed in a closed rack assembly, the operating temperature of the rack environment

may be greater than the room ambient temperature. Use care not to exceed the 45°C maximum ambient temperature of the

platform.

● Reduced air flow—Install the equipment in the rack so that the amount of airflow required for safe operation of the

equipment is not compromised.

● Reliable earthing—Maintain reliable earthing of rack-mounted equipment. Pay particular attention to the supply connections

other than the direct connections to the branch circuit, for example, use of power strips.

● Do not mount the equipment with the back panel facing downward.

Alternative mounting positions

How to reverse the rail mounting brackets.

If the users want to front-mount (flush-mount) the unit, remove and re-position the L-brackets with the following steps:

1. Remove 8x M3 screws on each rail assembly with number 1 Phillips screw driver.

Figure 8. Remove 8x M3

2. Reverse the small bracket. Secure bracket with 8X M3 screws. Torque to 3 In/lbs.

VEP4600 installation