Allied Telesis Rapier 24i Manual de instalação rápida - Página 10

Procurar online ou descarregar pdf Manual de instalação rápida para Software Allied Telesis Rapier 24i. Allied Telesis Rapier 24i 11 páginas. Rapier switch
Também para Allied Telesis Rapier 24i: Ficha de dados (6 páginas), Manual de instalação rápida (12 páginas), Ficha de dados (3 páginas), Ficha de dados (3 páginas), Ficha de dados (2 páginas), Brochura (8 páginas), Manual suplementar (6 páginas), Manual de instalação rápida (13 páginas), Manual de instalação rápida (12 páginas)

Imprimir página
Allied Telesis Rapier 24i Manual de instalação rápida
10
System LEDs and What They Mean
System LEDs on its front panel indicate the switch's operational status.
System LEDs
LED
State
Power
Green
Fault
Red
1 flash
3 flashes
4 flashes
5 flashes
1
RPS
(Redundant
Green
Power Supply)
2
In use
(Rear panel)
Green
Off
2
Swap
(Rear panel)
Green
Off
1. DC models of the Rapier Switch do not have an RPS connector and the RPS LED will not function.
2. Not included on the Rapier 48, G6, G6F-SX/SC, G6F-LX/SC, or G6F-SX/MT-RJ.
3. Hot swapping is supported by Software Release 2.3.1 or later. AT-AR021 (S) BRI-S/T, AT-AR021 (U)
BRI-U, AT-AR022 ETH, AT-AR023 SYN, and AT-AR026 4ETH PICs can be hot swapped.
The Rapier Switch Hardware Reference has further troubleshooting information,
including information on Switch Port and Uplink Module LEDs.
Function
The switch is receiving power and the voltage
is within the acceptable range
The switch or management software is
malfunctioning
A switch fan has failed. (The LEDs will not
indicate an RPS fan failure.)
If an RPS is connected, the switch's PSU (Power
Supply Unit) has failed
If RPS monitoring is enabled, the RPS PSU has
failed
If RPS monitoring is enabled, an RPS is not
connected or is not operational
An RPS is connected to the switch
An NSM is installed, is receiving power, and is
operational. The NSM and its PICs are not
ready to be hot swapped
No NSM is installed, or the NSM is not installed
correctly (the switch unit has not recognised
the NSM)
The NSM and its PICs are ready to be hot
swapped
The Hot Swap button must be pressed before
the NSM or PICs can be hot swapped, or the
software release does not support hot
3
swapping
Rapier Switch
Software Release 2.3.1
C613-04017-01 REV D