Dell EMC Integrated Data Protection Appliance DP4400 Manual de instalação do hardware - Página 7
Procurar online ou descarregar pdf Manual de instalação do hardware para Armazenamento Dell EMC Integrated Data Protection Appliance DP4400. Dell EMC Integrated Data Protection Appliance DP4400 18 páginas. Emc integrated data protection appliance
Imprimir página
- 1. Table of Contents
- 2. Installation Overview
- 3. Prepare the Site and Unpack the System
- 4. Install Network Validation Tool
- 5. Install the Rails
- 6. Secure the Rails to the Cabinet
- 7. Install the System in the Cabinet
- 8. Install the Bezel
- 9. Connect the System to the Network
- 10. Connect the Power Cables and Power on
- 11. Configure Idrac
- 12. Installing the Dataprotection-ACM Pre-Installation Patch
- 13. Launch the Appliance Configuration Manager
- 14. Additional Resources
Secure the rails to the cabinet
Figure 2 Installing the front end of the rail
6. Repeat the preceding steps to install the right rail assembly.
The supplied screws and washers are used to secure the rail assemblies to the front
and rear of the cabinet.
Note
For square hole cabinets, install the supplied conical washer before installing the
screw. For unthreaded round hole cabinets, install only the screw without the conical
washer.
Procedure
1. Align the screws with the designated U spaces on the front and rear rack
flanges.
Ensure that the screw holes on the tab of the system retention bracket are
seated on the designated U spaces.
2. Insert and tighten the two screws using the Phillips #2 screwdriver.
Secure the rails to the cabinet
7