Dell EqualLogic PS Series Manual do Proprietário do Hardware - Página 29
Procurar online ou descarregar pdf Manual do Proprietário do Hardware para Armazenamento Dell EqualLogic PS Series. Dell EqualLogic PS Series 48 páginas. Storage arrays
Também para Dell EqualLogic PS Series: Configuração (2 páginas), Manual do Proprietário do Hardware (50 páginas), Manutenção de hardware (46 páginas)
Imprimir página
PS6210 Hardware Owner's Manual
Facing the rear of the array, the upper control module is CM0 and the lower control module is CM1, as
shown in
Figure
20.
To install a control module:
1. Attach an electrostatic wrist strap or similar protective device. See
1.
2. Push down on the orange release tab (callout 1 in
3. Slide the control module into the chassis until it is even with the installed controller. The lever
should swing smoothly until it is in the locked position.
4. Rotate the lever inward, which pushes the control module completely into the slot. The latch on the
lever will snap into place.
5. Connect all cables (network and serial port).
6. If the array was shut down, turn on power to the array.
7. Make sure the control module is operational. See
The Type 15 control module contains an integral battery assembly used in the cache-to-flash fea-
ture of the control module. If the Group Manager GUI or CLI indicates a battery failure, the bat-
tery must be replaced.
If two control modules are installed in the array, but only one is shown in the GUI (or CLI), make
sure that you have allowed enough time (minimum of 5 minutes) for the two control modules to boot
and synchronize. When synchronization completes, a message appears on the serial console (if con-
nected), and the ACT LED on the secondary module is illuminated amber.
Figure 20: Correct Control Module Orientation
Figure 21: Installing a Control Module (4U Array)
3 Maintaining Control Modules
Protecting Hardware on page
Figure
21) and swing the lever out (callout 2).
Interpreting Control Module LEDs on page
16.
23