Dell PowerVault 136T LTO Manual de atualização - Página 3
Procurar online ou descarregar pdf Manual de atualização para Armazenamento Dell PowerVault 136T LTO. Dell PowerVault 136T LTO 42 páginas. Update the lto-1 tape drive modules to lto-2 tape drive modules
Também para Dell PowerVault 136T LTO: Upgrade Manual (50 páginas), Manual (20 páginas), Manual (28 páginas)
Imprimir página
This document provides procedures for updating your LTO-1 tape drive module to an
LTO-2 tape drive module in the Dell™ PowerVault™ 136T LTO tape library. You must
perform the following procedures to complete the update:
•
Removing the LTO-1 drive modules
•
Installing the LTO-2 drive modules
•
Updating the tape library firmware
Removing the LTO-1 Drive Modules
NOTICE: You must fully complete the update from an LTO-1 tape library to an LTO-2 tape
library. LTO-1 tape drive modules and LTO-2 tape drive modules cannot be present in the same
tape library.
CAUTION: Before performing this procedure, read and follow the safety
instructions in your System Information Guide.
Shut down the tape library.
1
From the back of the library, remove the drive module by loosening the two captive
2
thumbscrews on each sled. See Figure 1-1.
Slide the drive module out by its handle.
3
NOTE: If you are installing more LTO-2 drive modules than LTO-1 drive modules that you
just removed, then beginning with the lowest-available plate, remove the additional filler
plates by loosening the two captive thumbscrews.
Installing the LTO-2 Tape Modules
CAUTION: Before performing this procedure, read and follow the safety
instructions in your System Information Guide.
Slide the new LTO-2 drive modules into place beginning with the lowest-available
1
slot. See Figure 1-1.
Tighten the two captive thumbscrews on each drive module.
2
NOTE: If you are installing fewer LTO-2 drive modules than LTO-1 drive modules that you
just removed, then install a filler plate in each empty drive slot.
Updating Tape Drive Modules
1-1