Dell PowerVault MD3000 Manual de afinação - Página 6

Procurar online ou descarregar pdf Manual de afinação para Armazenamento Dell PowerVault MD3000. Dell PowerVault MD3000 32 páginas. Wwn
Também para Dell PowerVault MD3000: Brochura (4 páginas), Matriz de apoio (21 páginas), Configuração (2 páginas), Manual de iniciação (43 páginas), Procedimento de atualização (8 páginas)

Dell™ PowerVault MD3000 and MD3000i Array Tuning Best Practices

• Profile of mean I/O direction; this is usually the ratio of Reads to Writes

4 Configuring the MD3000/MD3000i

There are two ways to configure the MD3000 and MD3000i storage systems.

The most common and easiest method is using the MDSM. The MDSM allows

automatic configuration settings that provide reasonable configurations with little

knowledge of performance tuning required.

A manual configuration option is also available using the command line interface

(CLI), providing more flexibility but requiring more knowledge of performance

requirements.

For a link to the MDSM and CLI guides, see Appendix C: References.

The first step involved in tuning an MD3000 or MD3000i external storage array is

to determine the RAID level most appropriate for the solutions given the

application. In the proceeding document, please note that RAID 0 is excluded

from most information in this paper due to the lack of data protection. This does

not mean the use of RAID 0 is undesired, just that it should only be used for non-

critical data. In general, RAID 0 generally provides better performance than RAID

1/10, 5 or 6. Additionally, RAID 6 is not always referenced specifically; most

comments applicable to tuning RAID 5 are directly applicable to RAID 6 unless

otherwise noted. In situations where the increased fault tolerance provided by

RAID 6 are desired, please note that a performance penalty is observed when

compared directly to RAID 5 due to the additional parity calculation and the extra

physical disk required for implementation.

An important consideration when determining the appropriate RAID level is the

physical disk cost required by a RAID level. Physical disk cost, is the number of

physical drives worth of capacity that are sacrificed to provided the desired data

integrity level. The physical disk cost of each RAID level is different, and may

impact the decision for which RAID level is most appropriate for a chosen

environment. RAID 0, having no level of redundancy has a physical disk cost of

zero. RAID 1/10 has the highest disk-cost in disk groups containing more than 2

drives. Half of the physical drives in a RAID 1/10 are always consumed for the

mirror. RAID 5 has a fixed 1-physical disk per disk-group cost, i.e. with a RAID 5

set of n disks, only n-1 worth of capacity is available. Similarly, RAID 6 has a

fixed two physical disks per disk-group cost, or n-2. In RAID 5 and 6, these extra

drives account for the space required to maintain the levels of parity information

for each stripe.

December 2008 – Revision A01

Page 6