Dell PowerVault MD3200i Series Manual de implantação - Página 37

Procurar online ou descarregar pdf Manual de implantação para Armazenamento Dell PowerVault MD3200i Series. Dell PowerVault MD3200i Series 41 páginas. Storage arrays
Também para Dell PowerVault MD3200i Series: Manual de atualização (32 páginas), Instruções de instalação do bastidor (2 páginas), Manual do utilizador (46 páginas), Matriz de apoio (12 páginas), Manual de instalação (18 páginas), Atualização da informação (1 páginas), Matriz de apoio (11 páginas), Matriz de apoio (17 páginas), Manual técnico (38 páginas), Livro Branco (22 páginas), Manual (16 páginas)

Imprimir página
Dell PowerVault MD3200i Series Manual de implantação
Dell PowerVault MD32xxi Configuration Guide for VMware ESX4.1 Server Software
Switch Name Num Ports Used Ports Configured Ports MTU Uplinks
vSwitch2
64
PortGroup Name VLAN ID Used Ports
iSCSI6
iSCSI5
iSCSI4
iSCSI3
iSCSI2
iSCSI1
You can see that there are two vmnics in each uplink for each VMkernel Port. This is what we need to
change so that only a single vmnic is in each uplink and that we manually load balance them across all
available VMkernel Ports.
To configure this process via CLI first note the vmnic number of the NICs you want to remove and type the
following command:
esxcfg-vswitch –p iSCSI1 –N vmnic3 vSwitch2
What this will do is remove vmnic3 from VMkernel port iSCSI1 so that just vmnic2 is on iSCSI1.
We then need to do the same thing for the other 4 VMkernel ports making sure to remove vmnics so that
an equal number of VMkernel ports are on each vmnic (3 per vmnic).
esxcfg-vswitch –p iSCSI2 –N vmnic3 vSwitch2
esxcfg-vswitch –p iSCSI3 –N vmnic3 vSwitch2
esxcfg-vswitch –p iSCSI4 –N vmnic2 vSwitch2
esxcfg-vswitch –p iSCSI5 –N vmnic2 vSwitch2
esxcfg-vswitch –p iSCSI6 –N vmnic2 vSwitch2
In an example where there are 3 or more vmnics, you would remove each one from the vSwitch to make
sure there is only a single vmnic per uplink.
To verify that this was done correctly type the following command:
esxcfg-vswitch –l
The output will look similar to this:
Switch Name Num Ports Used Ports Configured Ports MTU Uplinks
vSwitch2
64
PortGroup Name VLAN ID Used Ports
iSCSI6
iSCSI5
iSCSI4
iSCSI3
iSCSI2
iSCSI1
9
64
Uplinks
0
1
0
1
0
1
0
1
0
1
0
1
9
64
Uplinks
0
1
0
1
0
1
0
1
0
1
0
1
9000 vmnic3,vmnic2
vmnic2,vmnic3
vmnic2,vmnic3
vmnic2,vmnic3
vmnic2,vmnic3
vmnic2,vmnic3
vmnic2,vmnic3
9000 vmnic3,vmnic2
vmnic3
vmnic3
vmnic3
vmnic2
vmnic2
vmnic2
Page 35