Dell PowerVault TL4000 Manual do utilizador - Página 16

Procurar online ou descarregar pdf Manual do utilizador para Armazenamento Dell PowerVault TL4000. Dell PowerVault TL4000 20 páginas. Tape library
Também para Dell PowerVault TL4000: Notas de lançamento (3 páginas), Começar a trabalhar (38 páginas), Perguntas frequentes (26 páginas), Manual de início rápido (7 páginas), Manual do software (16 páginas), Manual de configuração (22 páginas), Manual de informações importantes (10 páginas), Adenda ao Manual do Utilizador (2 páginas), Manual de iniciação (3 páginas), Instruções de anexação (17 páginas), Brochura (4 páginas)

Laser Safety and Compliance

Before using the library, review the following laser safety information.

Class I Laser Product

The library may contain a laser assembly that complies with the performance

standards set by the U.S. Food and Drug Administration for a Class I laser

product. Class I laser products do not emit hazardous laser radiation. The library

has the necessary protective housing and scanning safeguards to ensure that laser

radiation is inaccessible during operation or is within Class I limits. External safety

agencies have reviewed the library and have obtained approvals to the latest

standards as they apply.

Performing the Safety Inspection Procedure

Before you service the unit, perform the following safety inspection procedure:

10. Check the product label at the rear of the library to make sure that it matches

xiv

Dell PowerVault TL2000 Tape Library and TL4000 Tape Library User's Guide

1. Stop all the activities between the host and the library's tape drives.

2. Turn off the power to the library by pushing in on the Power button (1)

shown in Figure 1-1 on Page 1-1 for 4 seconds.

3. If drives are SCSI attached, disconnect the SCSI cable and check the SCSI bus

terminator for damage.

4. Unplug the library's power cord or cords from the electrical outlet and the

library power supply.

5. Check the library's power cord for damage, such as a pinched, cut, or frayed

cord.

6. If drives are SCSI attached, check the tape drive's SCSI bus (signal) cable for

damage.

7. If drives are FC/SAS attached, check the tape drive's FC/SAS cable for

damage.

8. Check the cover of the library for sharp edges, damage, or alterations that

expose its internal parts.

9. Check the cover of the library for proper fit. It should be in place and secure.

the voltage at your outlet.