Dell 1N25N Atualização do Firmware - Página 6

Procurar online ou descarregar pdf Atualização do Firmware para Interruptor Dell 1N25N. Dell 1N25N 14 páginas.

Imprimir página
Dell 1N25N Atualização do Firmware
Firmware Upgrade Procedure Dell™ Networking N2100 Series Switches
console#show version
Machine Description............... Dell Networking Switch
System Model ID................... N2128PX-ON
Machine Type...................... Dell Networking N2128PX-ON
Serial Number..................... 15114M0002LF
Manufacturer...................... 0xbc00
Burned In MAC Address............. 001E.C9E5.BD0F
System Object ID.................. 1.3.6.1.4.1.674.10895.3066
SOC Version....................... BCM56150_A0
HW Version........................ 1
CPLD Version...................... 16
unit active
---- ----------- ----------- -------------- --------------
1
6.3.6.4
NOTE:
Set the image to use as the boot (active) image after the switch
resets. Images on the N2128PX-ON series switches are named active and
backup.
4. Activate the
6.3.6.9
console#boot system backup
Activating image backup ..
5. Reload the switch.
console#reload
Management switch has unsaved changes.
Are you sure you want to continue? (y/n) y
Configuration Not Saved!
Are you sure you want to reload the stack? (y/n) y
NOTE:
If using the serial port to update the firmware, the following output
will be observed. If logged in via telnet or SSH, rebooting the switch will close
the connection. Rebooting may take several minutes to complete and the
switch may reboot itself more than once during the upgrade procedure.
Reference platform resetting ...
Unmounting config filesystem...
starting pid 1700, tty '': '/etc/rc.d/rc.rebootRebooting system!
The system is going down NOW!
Sent SIGTERM to all processes
Sent SIGKILL to all processes
Requesting system reboot
U-Boot SPL 2012.10-g8642dcd (Jan 19 2017 - 13:14:29)
DCO:
35 (PASS)
Device:Helix4 (0xdc14)
SKU:
Unknown (0xb547)
DRAM:
DDR3, 750MHz
Validate DDR shmoo parameters stored in flash ..... OK
Press Ctrl-C to run DDR shmoo ..... skipped
Restoring DDR shmoo parameters from flash ..... done
Running simple memory test ..... OK
DDR Interface Ready
(ONFI), MT29F32G08ABAAAWP
NAND:
1024 KiB blocks, 8 KiB pages, 16B OOB, 8-bit
NAND:
chipsize
U-Boot 2012.10-g8642dcd (Jan 19 2017 - 13:14:29) - ONIE 4.30.1.2 - Bristol N2128PX V1.0.5
backup
current-active next-active
6.3.6.9
6.3.6.4
firmware
, blocks per lun: 1000 lun count: 1
6.3.6.4
Page 4