Dell DF10MXL Manual de iniciação - Página 31
Procurar online ou descarregar pdf Manual de iniciação para Interruptor Dell DF10MXL. Dell DF10MXL 36 páginas. Networking mxl 10/ 40gbe switch io module
Imprimir páginastack-unit unit-number: Enter the number of the stack unit to be
reset. Range: 0-5. To display the stack-unit number, enter the show
system brief command.
port port-number: Enter the port number of the 40GbE QSFP+ port
to be split. Valid values on base module: 33 or 37; slot 0: 41 or 45;
slot 1: 49 or 53.
portmode quad: Identifies the uplink port as a split 10GbE SFP+
port.
Then save the configuration and reload the switch.
Dell# write memory
Dell# reload
To change a port from 4x10GbE to 40GbE mode of operation, enter the
no stack-unit port portmode quad command, save the configuration, and
reload the switch.
To display the current 40GbE or 4x10GbE mode of port operation, enter
the show running-config command.
Switch Configuration
After you complete the initial switch configuration, the MXL 10/40GbE
Switch is operational. You must manually configure the switch to enable
software features, such as:
•
Data center bridging capability exchange protocol (DCBX)
•
Fiber Channel over Ethernet (FCoE) connectivity
•
FCoE initiation protocol (FIP) snooping
•
iSCSI optimization
•
Internet group management protocol (IGMP) snooping
•
Remote authentication dial-in service (RADIUS) support
•
Terminal access controller access control system plus (TACACS+) client
For information about how to configure switch software, refer to the
Configuration Guide for the Dell Networking MXL 10/40 GbE Switch IO
Module on the Dell Support website at http://support.dell.com/manuals.
Switch Configuration
31