Dell Force10 S4810P Manual de início rápido - Página 7

Procurar online ou descarregar pdf Manual de início rápido para Interruptor Dell Force10 S4810P. Dell Force10 S4810P 27 páginas. Quick start guide

Installing the Hardware

This guide assumes all site preparation has been performed before installing the

chassis.

Installing the S4810 Chassis in a Rack or

Cabinet

To install the S4810 system, Dell Force10 recommends that you complete the

installation procedures in the order presented below.

Always handle the system and its components with care. Avoid dropping the

S4810 chassis or its field replaceable units.

For proper ventilation, position the S4810 chassis in an equipment rack (or

cabinet) with a minimum of five inches (12.7 cm) of clearance around exhaust

vents. The acceptable ambient temperature ranges are listed in the

Environmental Parameters section.

CAUTION: Always wear an ESD-preventive wrist or heel ground strap when

handling the S4810 and its components. As with all electrical devices of this

type, take all necessary safety precautions to prevent injury when installing

this system. Electrostatic discharge (ESD) damage can occur if components

are mishandled.

Attaching Mounting Brackets

The S4810 is shipped with mounting brackets (rack ears) and required screws

for rack or cabinet installation. The brackets are enclosed in a package with the

chassis.

Step

Task

Take the brackets and screws out of their packaging.

Installing the Hardware