Dell Force10 Z9000 Manual de início rápido - Página 10

Procurar online ou descarregar pdf Manual de início rápido para Interruptor Dell Force10 Z9000. Dell Force10 Z9000 25 páginas. Dell force10 z9000 system quick start guide

Imprimir página

Step

Task

Insert the optic into the port until it gently snaps into place.

NOTE:

inserted with the tabs facing up.

Splitting QSFP Ports to SFP+ Ports

The Z9000 supports splitting a single 40G QSFP port into four 10G SFP+ ports

using one of the supported breakout cables.

You must enter the stack-unit portmode command for the system to recognize

the port type change. For example: stack-unit stack-unit port number

portmode quad

•

stack-unit: Enter the stack member unit identifier of the stack member to

reset. Range: 0-11

•

number: Enter the port number of the 40G port to be split. Range: 0-31

Important Points

•

Splitting a 40G port into 4x10G port is supported only on a standalone unit.

•

Split ports cannot be used as stack-link to stack a Z9000.

•

Split ports Z9000 unit cannot be a part of any stacked system.

•

The unit number with the split ports must be the default (stack-unit 0). This

can be verified using the show system brief command. If the unit ID is

different than 0, then it must be renumbered to 0 before ports are split, by

entering in EXEC mode: stackunit id renumber 0

•

The quad port must be in a default configuration before it can be split into

4x10G ports. The 40G port is lost in the running-configuration when the port

is split, so be sure the port is also removed from other L2/L3 feature

configurations.

•

The system must be reloaded after issuing the CLI for the change to take

effect.

Install the Solid State Drive

The Z9000 includes a Solid State Drive (SSD) that acts as another storage

device. The SSD is shipped installed with the Z9000 system, and is located in a

slot on the lower-right area on the I/O side.

Installing the Hardware

Both rows of QSFP+ ports require that the 40G optics be