Dell N1124T-ON Manual de iniciação - Página 11
Procurar online ou descarregar pdf Manual de iniciação para Interruptor Dell N1124T-ON. Dell N1124T-ON 27 páginas.
Imprimir página
- 1. Getting Started Guide
- 2. N1100-On Series Hardware Overview
- 3. N1124T-On/N1124P-On/N1148T-On/ N1148P-On Installation
- 4. Starting and Configuring the N1100-On Series Switch
- 5. Connecting an N1100-On Series Switch to a Terminal
- 6. Performing the N1100-On Series Initial Configuration
- 7. Enabling Remote Management
- 8. Initial Configuration Procedure
Figure 1-4. Bracket Installation for Wall Mounting
3 Insert the supplied screws into the wall-mounting bracket holes and
tighten with an M5x32 screwdriver.
4 Repeat the process for the wall-mounting bracket on the other side of the
switch.
5 Place the switch on the wall in the location where the switch is being
installed.
6 On the wall mark the locations where the screws to hold the switch must
be prepared.
7 On the marked locations, drill the holes and place all plugs (not provided)
in the holes.
8 Secure the switch to the concrete wall or wood material with screws (not
provided). Make sure that the ventilation holes are not obstructed.
Installing as a Free-standing Switch
NOTE:
Dell strongly recommends mounting the switch in a rack.
Install the switch on a flat surface if you are not installing it in a rack. The
surface must be able to support the weight of the switch and the switch
cables. The switch is supplied with four self-adhesive rubber pads.
1 Attach the self-adhesive rubber pads on each location marked on the
bottom of the switch.
Getting Started Guide
11