Dell Networking N2024P Manual de instalação - Página 12

Procurar online ou descarregar pdf Manual de instalação para Interruptor Dell Networking N2024P. Dell Networking N2024P 49 páginas.
Também para Dell Networking N2024P: Atualização de firmware (21 páginas)

Dell Networking N2024P Manual de instalação

Rack Mounting an N20xx Switch

WARNING:
Read the safety information in the
that connect to or support the switch.
The AC power connector is on the PSU-side of the switch.

Installing in a Rack

WARNING:
Do not use rack mounting kits to suspend the switch from under a table or desk, or attach it to a wall.
CAUTION:
Disconnect all cables from the switch before continuing. Remove all self-adhesive pads from the underside of the
switch, if they have been attached.
CAUTION:
When mounting multiple switches into a rack, mount the switches from the bottom up.
1
Align the holes on the right rack-mount bracket with the holes on the right side (facing you) of the switch.
2
Secure the bracket (item 3) to the chassis by tightening the screws (item 2) provided with the mount bracket.
Figure 6. Attaching Mount Brackets to the N20xx
3
Repeat Steps 1 and 2 to attach the left rack-mount bracket on the device.
4
Mount the switch into a 48.26 cm (19 inch) rack. Align the holes on each bracket flange with the holes on a rack post.
5
Secure the switch to the rack using the rack bolts (provided with the mount brackets) or cage nuts and cage-nut bolts with washers
(provided with the rack). Tighten the bolts on the bottom of each bracket flange first; then tighten the bolts on top (item 1).
CAUTION:
Make sure that the supplied rack bolts fit the pre-threaded holes in the rack.
NOTE:
Do not obstruct the ventilation holes.
Safety and Regulatory Information and the safety information for other switches
N20xx Series Installation
11