Avvio PAD 2 Manual do utilizador - Página 18

Procurar online ou descarregar pdf Manual do utilizador para Tablet Avvio PAD 2. Avvio PAD 2 20 páginas.

FCC Regulations

This device complies with part 15 of the FCC Rules. Operation is

subject to the following two conditions: (1) This device may not

cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause

undesired operation.

This device has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates,

uses and can radiated radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation If

this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

Caution: Changes or modifications not expressly approved by the

party responsible for compliance could void the user's authority to

operate the equipment.

This device is designed and manufactured not to exceed the

emission limits for exposure to radio frequency (RF) energy set by

the Federal Communications Commission of the United States.

During SAR testing, this device was set to transmit at its highest

certified power level in all tested frequency bands, and placed in

positions that simulate RF exposure in usage against the head with

no separation, and near the body with the separation of 0 mm.

Although the SAR is determined at the highest certified power level,

the actual SAR level of the device while operating can be well below

the maximum value. This is because the device is designed to