3 Day Blinds ROLLER SHADE Começar a trabalhar - Página 3

Procurar online ou descarregar pdf Começar a trabalhar para Estores de janela 3 Day Blinds ROLLER SHADE. 3 Day Blinds ROLLER SHADE 8 páginas. Continuous cord loop and link system with cassette, continuous cord loop with side channels

Imprimir página
TENSIONER INSTALLATION
After installing the window covering, the Cord Tensioner must
be mounted for the window covering to operate correctly.
When properly installed, the Cord Tensioner functions as
a safety device that makes the pull cord less accessible
to children.
NOTE: If the mounting screws will not be secured into a wood
stud, use wall anchors. For metal surfaces, pre-drill the holes
and use sheet metal screws.
IMPORTANT!
• Install the Cord Tensioner in a location that minimizes
accessibility to children and pets and where it will not
interfere with its operation.
• Only supplied Cord Tensioners and hardware should be used.
MOUNTING OPTIONS
Option A - Inside mount without an anchor
Cord Tensioner used in an inside mount application without
a mounting bracket.
• Locate the Cord Tensioner as close to the window as
possible to minimize accessibility by children and pets.
Be sure the Cord Tensioner is not placed in the path of
the window covering when raising and lowering.
Inside Mount
(1 Screw)
Option B - Inside mount with an anchor
Cord Tensioner using the mounting bracket in an inside
mount application.
• Locate the Cord Tensioner as close to the window as
possible to minimize accessibility by children and pets.
Be sure the Cord Tensioner is not placed in the path of
the window covering when raising and lowering.
Inside Mount
(3 Screws)
3
| Cassettes and Side Channels
Option C - Outside Mount
Cord Tensioner using the mounting brackets in an outside
mount application.
• Locate the Cord Tensioner as close to the window as
possible to minimize accessibility by children and pets.
Be sure the Cord Tensioner is not placed in the path of
the window covering when raising and lowering.
Option D - Outside Mount with Side Channels
• All tensioners must be affixed to the side channel as
specified to ensure bottom rail function is not affected.
• Drill a pilot hole into the face of the metal side channel
10mm (slightly more than 3/8" from the edge of the channel.
TOP VIEW
10mm