Dell PowerConnect 6248 Nota de lançamento - Página 29
Procurar online ou descarregar pdf Nota de lançamento para Interruptor Dell PowerConnect 6248. Dell PowerConnect 6248 34 páginas. Powerconnect 6200 series
Também para Dell PowerConnect 6248: Especificações (2 páginas), Manual de planeamento e preparação (12 páginas)
Imprimir página
PowerConnect 6224/6224F/6224P/6248/6248P Release Notes
Summary
User Impact
ISDP updates are not
Upon changing configuration immediately
including Voice VLAN
after getting the VLAN assigned, DUT stops
Reply TLV when
advertising Voice VLAN reply TLV in its
Voice VLAN ID on
ISDP updates which causes IP phone to
interface is changed.
change its VLAN properties.
PC6200 fails to re-
Once a phone is configured, enable Voice
authorize IP phone
VLAN authentication, wait for DHCP
upon enabling and
discovery again, and then disable Voice
disabling Voice VLAN
VLAN authorization. On disabling Voice
authentication.
VLAN authorization, PC6200 fails to
authorize IP phone based on the received
LLDP packet (with network policy TLV).
When Line or enable
If login authentication method is Line or
method is used as
Enable, and enable authentication is None,
login method and
you will always get read-only access
enable authentication
(because there is no user configured for line
is none, the user is
or enable authentication). The user will
unable to enter into
never get read-write access.
Privileged EXEC
mode.
Cannot change LAG
Cannot change LAG mode from Static to
mode from Static to
Dynamic via CLI.
Dynamic via CLI.
System Firmware Version 3.2.0.6
Workaround
The administrator can work around this
problem by shutting down the port and
restarting it after the configuration is
changed.
Disconnect and reconnect the phone to the
port, the phone gets authorized.
If enable authorization is set to None, ensure
that the login authorization method is at least
TACACS, Radius, or Local. Any
authentication method that requires a user
configuration will ensure that the user will get
proper access based on how the user is
configured.
The user may change the LACP Mode using
the Graphical User Interface.
Page 27