Dell PowerConnect 8024 Notas de lançamento - Página 13
Procurar online ou descarregar pdf Notas de lançamento para Interruptor Dell PowerConnect 8024. Dell PowerConnect 8024 20 páginas. Upgrading from version 2.x.x.x or 3.x.x.x or 4.x.x.x or 5.x.x.x to 5.1.9.3 firmware
Também para Dell PowerConnect 8024: Notas de lançamento (27 páginas), Manual de configuração (21 páginas), Atualização do Firmware (24 páginas)
Description
guest-vlan-timeout' command is
missing from CLI.
System LED state/color is not correct.
Switch is accepting IGMPv2 Joins
with TTL as 64.
Static IP cannot be configured from
WEB
Switch hangs when invalid image is
downloaded into script
IGMP Querier does not work if IP
Multicast not enabled.
Sending multiple DHCP discoveries to
the switch results in log messages on
the console.
Radius Servers always show active
status.
Interface Configuration web page
would not allow the user to set the
MTU size to zero.
Missing RFC1213 MIB-2 SNMP Trap
counter
System Firmware Version 3.1.4.16
PowerConnect 8024/8024F Release Notes
User Impact
User cannot configure the guest-vlan-
timeout period. Since the default
timeout is 30 sec's, this may be too
long before host is put into the guest
VLAN causing such issues as DHCP
clients' timeouts waiting for DHCP
ACK's.
System LED does not indicate if both
images are invalid or one of the
fan/power module reports failure or
system temperate exceeds threshold.
Multicast traffic may get forwarded to
the unwanted user.
Static IP cannot be configured from
WEB, as session is getting lost as
soon as the protocol is set to None.
Switch hangs when invalid image is
downloaded into script
User must enable IP multicast in order
for IGMP Querier to work.
Sending multiple DHCP discoveries to
the switch results in log messages on
the console.
The RADIUS Server Status web page
was always displaying the server's
status as active.
Interface Configuration web page
restricted the user to configure the IP
MTU from 68-9198.
System did not provide values for mib-
2, snmp, snmpOutTraps (Oid
.1.3.6.1.2.1.11.29).
Resolution
Added the new CLI command.
Modified system LED algorithm to
reflect the correct status.
Added additional checks in packet
Rx process.
Corrected dependencies in web to
allow confirmation of static IP from
Web.
Added a check to raise an error if a
downloaded script file is binary or if
it does not contain any commands.
Automatically enable IP Multicast
when IGMP is enabled.
Driver modified to handle MAC
addresses correctly.
Retrieved the server status the
same as the CLI for each row in the
web page display.
Changed the weg page IP MTI field
do allow the following values to be
configured: 0 or 68-9198.
Re-enabled objects to provide
support even though they are
obsolete in RFC-1907.
Page 11