Dell PowerConnect J-EX4200 Nota de lançamento - Página 12
Procurar online ou descarregar pdf Nota de lançamento para Interruptor Dell PowerConnect J-EX4200. Dell PowerConnect J-EX4200 14 páginas. Release notes junos version 10.2
Também para Dell PowerConnect J-EX4200: Manual de início rápido (24 páginas)
JUNOS 10.2 Software Release Notes
Related Topics
12
continues to display page 3 and shows no results. To view the results, navigate to page
1 manually. [PR/476338]
In the J-Web interface, the dashboard does not display the uplink ports or uplink module
ports when transceivers are not plugged into the ports. [PR/477549]
An IPv4 static route that has been configured using the CLI might not be displayed
when you select the Configure > Routing > Static Routing option in the J-Web interface.
[PR/483885]
In the J-Web interface, when you use the point-and-click configuration editor to change
configuration and if you have made configuration changes simultaneously using the
CLI, committing the configuration from J-Web might fail. [PR/514771]
In the J-Web interface, no warnings are displayed when you have configuration changes
that are not committed and when you upload and install software packages or reboot
the switch. [PR/514853]
In the J-Web interface, if RIP, BGP, OSPF, and DHCP are not configured, you cannot
click the links Commit, Help, and Logout in the monitoring pages for RIP, BGP, OSPF,
and DHCP because the message "Not configured" that appears on these pages masks
the Commit, Help, and Logout links in the J-Web interface. [PR/528346]
Layer 2 and Layer 3 Protocols
If an J-EX8200 switch receives an IGMP packet of unknown type, the switch might
flood the packet on all interfaces, including the ingress interface from which the packet
was received. [PR/502248]
On J-EX4200 switches, if you have configured MTU on a logical interface and the route
information for an inactive route on the interface changes, traffic loss might occur for
a few seconds. [PR/520448]
Virtual Chassis
On J-EX4200 switches, factory default configuration does not set the configuration
required for pre-provisioning, causing the
reset-virtual-chassis-configuration
reset to the factory default configuration. As a workaround, delete the
from the
directory and reset the switch to factory default configuration.
config
[PR/506855]
New Features in JUNOS Release 10.2 for J-EX Series Switches on page 3
Changes in Default Behavior and Syntax in JUNOS Release 10.2 for J-EX Series Switches
on page 5
Limitations in JUNOS Release 10.2 for J-EX Series Switches on page 6
set system commit factory-settings
command to be not available after the switch is
junos.conf*
files